diff mbox

[3/6] ARM: dts: imx6qdl-tx6: add ENET_OUT clock to fec node

Message ID 1453294626-17608-4-git-send-email-LW@KARO-electronics.de
State New
Headers show

Commit Message

Lothar Waßmann Jan. 20, 2016, 12:57 p.m. UTC 
ENET_OUT is used as reference clock for the ethernet PHY on the Ka-Ro
TX6 modules. Specify this clock in DTB to let it be managed correctly
by the driver.

Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
---
 arch/arm/boot/dts/imx6qdl-tx6.dtsi | 5 +++++
 1 file changed, 5 insertions(+)

Comments

Shawn Guo Feb. 2, 2016, 6:31 a.m. UTC | #1 
On Wed, Jan 20, 2016 at 01:57:03PM +0100, Lothar Waßmann wrote:
> ENET_OUT is used as reference clock for the ethernet PHY on the Ka-Ro
> TX6 modules. Specify this clock in DTB to let it be managed correctly
> by the driver.
> 
> Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>

Applied, thanks.
diff mbox

Patch

diff --git a/arch/arm/boot/dts/imx6qdl-tx6.dtsi b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
index 9404668..5e0afc8 100644
--- a/arch/arm/boot/dts/imx6qdl-tx6.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
@@ -227,6 +227,11 @@ 
 &fec {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_enet>;
+	clocks = <&clks IMX6QDL_CLK_ENET>,
+		 <&clks IMX6QDL_CLK_ENET>,
+		 <&clks IMX6QDL_CLK_ENET_REF>,
+		 <&clks IMX6QDL_CLK_ENET_REF>;
+	clock-names = "ipg", "ahb", "ptp", "enet_out";
 	phy-mode = "rmii";
 	phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_HIGH>;
 	phy-supply = <&reg_3v3_etn>;