@@ -77,18 +77,16 @@ static void hns_get_mdix_mode(struct net_device *net_dev,
return;
}
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr, HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_MDIX);
+ phy_write(phy_dev, HNS_PHY_PAGE_REG, HNS_PHY_PAGE_MDIX);
- retval = mdiobus_read(phy_dev->bus, phy_dev->addr, HNS_PHY_CSC_REG);
+ retval = phy_read(phy_dev, HNS_PHY_CSC_REG);
mdix_ctrl = hnae_get_field(retval, PHY_MDIX_CTRL_M, PHY_MDIX_CTRL_S);
- retval = mdiobus_read(phy_dev->bus, phy_dev->addr, HNS_PHY_CSS_REG);
+ retval = phy_read(phy_dev, HNS_PHY_CSS_REG);
mdix = hnae_get_bit(retval, PHY_MDIX_STATUS_B);
is_resolved = hnae_get_bit(retval, PHY_SPEED_DUP_RESOLVE_B);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr, HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_COPPER);
+ phy_write(phy_dev, HNS_PHY_PAGE_REG, HNS_PHY_PAGE_COPPER);
switch (mdix_ctrl) {
case 0x0:
@@ -253,53 +251,36 @@ static int hns_nic_config_phy_loopback(struct phy_device *phy_dev, u8 en)
if (en) {
/* speed : 1000M */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG, 2);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 21, 0x1046);
+ phy_write(phy_dev, HNS_PHY_PAGE_REG, 2);
+ phy_write(phy_dev, 21, 0x1046);
/* Force Master */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 9, 0x1F00);
+ phy_write(phy_dev, 9, 0x1F00);
/* Soft-reset */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 0, 0x9140);
+ phy_write(phy_dev, 0, 0x9140);
/* If autoneg disabled,two soft-reset operations */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 0, 0x9140);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 22, 0xFA);
+ phy_write(phy_dev, 0, 0x9140);
+ phy_write(phy_dev, 22, 0xFA);
/* Default is 0x0400 */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 1, 0x418);
+ phy_write(phy_dev, 1, 0x418);
/* Force 1000M Link, Default is 0x0200 */
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 7, 0x20C);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 22, 0);
+ phy_write(phy_dev, 7, 0x20C);
+ phy_write(phy_dev, 22, 0);
/* Enable MAC loop-back */
- val = (u16)mdiobus_read(phy_dev->bus, phy_dev->addr,
- COPPER_CONTROL_REG);
+ val = phy_read(phy_dev, COPPER_CONTROL_REG);
val |= PHY_LOOP_BACK;
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- COPPER_CONTROL_REG, val);
+ phy_write(phy_dev, COPPER_CONTROL_REG, val);
} else {
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 22, 0xFA);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 1, 0x400);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 7, 0x200);
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- 22, 0);
-
- val = (u16)mdiobus_read(phy_dev->bus, phy_dev->addr,
- COPPER_CONTROL_REG);
+ phy_write(phy_dev, 22, 0xFA);
+ phy_write(phy_dev, 1, 0x400);
+ phy_write(phy_dev, 7, 0x200);
+ phy_write(phy_dev, 22, 0);
+
+ val = phy_read(phy_dev, COPPER_CONTROL_REG);
val &= ~PHY_LOOP_BACK;
- (void)mdiobus_write(phy_dev->bus, phy_dev->addr,
- COPPER_CONTROL_REG, val);
+ phy_write(phy_dev, COPPER_CONTROL_REG, val);
}
return 0;
}
@@ -1018,16 +999,9 @@ int hns_phy_led_set(struct net_device *netdev, int value)
struct hns_nic_priv *priv = netdev_priv(netdev);
struct phy_device *phy_dev = priv->phy;
- if (!phy_dev->bus) {
- netdev_err(netdev, "phy_dev->bus is null!\n");
- return -EINVAL;
- }
- retval = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG, HNS_PHY_PAGE_LED);
- retval = mdiobus_write(phy_dev->bus, phy_dev->addr, HNS_LED_FC_REG,
- value);
- retval = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG, HNS_PHY_PAGE_COPPER);
+ retval = phy_write(phy_dev, HNS_PHY_PAGE_REG, HNS_PHY_PAGE_LED);
+ retval = phy_write(phy_dev, HNS_LED_FC_REG, value);
+ retval = phy_write(phy_dev, HNS_PHY_PAGE_REG, HNS_PHY_PAGE_COPPER);
if (retval) {
netdev_err(netdev, "mdiobus_write fail !\n");
return retval;
@@ -1052,19 +1026,15 @@ int hns_set_phys_id(struct net_device *netdev, enum ethtool_phys_id_state state)
if (phy_dev)
switch (state) {
case ETHTOOL_ID_ACTIVE:
- ret = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_LED);
+ ret = phy_write(phy_dev, HNS_PHY_PAGE_REG,
+ HNS_PHY_PAGE_LED);
if (ret)
return ret;
- priv->phy_led_val = (u16)mdiobus_read(phy_dev->bus,
- phy_dev->addr,
- HNS_LED_FC_REG);
+ priv->phy_led_val = phy_read(phy_dev, HNS_LED_FC_REG);
- ret = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_COPPER);
+ ret = phy_write(phy_dev, HNS_PHY_PAGE_REG,
+ HNS_PHY_PAGE_COPPER);
if (ret)
return ret;
return 2;
@@ -1079,20 +1049,18 @@ int hns_set_phys_id(struct net_device *netdev, enum ethtool_phys_id_state state)
return ret;
break;
case ETHTOOL_ID_INACTIVE:
- ret = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_LED);
+ ret = phy_write(phy_dev, HNS_PHY_PAGE_REG,
+ HNS_PHY_PAGE_LED);
if (ret)
return ret;
- ret = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_LED_FC_REG, priv->phy_led_val);
+ ret = phy_write(phy_dev, HNS_LED_FC_REG,
+ priv->phy_led_val);
if (ret)
return ret;
- ret = mdiobus_write(phy_dev->bus, phy_dev->addr,
- HNS_PHY_PAGE_REG,
- HNS_PHY_PAGE_COPPER);
+ ret = phy_write(phy_dev, HNS_PHY_PAGE_REG,
+ HNS_PHY_PAGE_COPPER);
if (ret)
return ret;
break;
Since we have a phydev, make use of it and the phy_read() function. This will help with later refactoring. Signed-off-by: Andrew Lunn <andrew@lunn.ch> --- v2: Revert hunks in IOCTL, which prevented access to arbitrary MDIO addresses. --- drivers/net/ethernet/hisilicon/hns/hns_ethtool.c | 104 ++++++++--------------- 1 file changed, 36 insertions(+), 68 deletions(-)