@@ -2417,7 +2417,7 @@ struct cfg80211_qos_map {
* @set_coalesce: Set coalesce parameters.
*
* @channel_switch: initiate channel-switch procedure (with CSA). Driver is
- * responsible for veryfing if the switch is possible. Since this is
+ * responsible for verifying if the switch is possible. Since this is
* inherently tricky driver may decide to disconnect an interface later
* with cfg80211_stop_iface(). This doesn't mean driver can accept
* everything. It should do it's best to verify requests and reject them
@@ -1169,7 +1169,7 @@ struct ieee80211_vendor_radiotap {
* @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only).
* This is the power save mode defined by IEEE 802.11-2007 section 11.2,
* meaning that the hardware still wakes up for beacons, is able to
- * transmit frames and receive the possible acknowledgment frames.
+ * transmit frames and receive the possible acknowledgement frames.
* Not to be confused with hardware specific wakeup/sleep states,
* driver is responsible for that. See the section "Powersave support"
* for more.
@@ -1460,7 +1460,7 @@ struct wireless_dev *ieee80211_vif_to_wdev(struct ieee80211_vif *vif);
* %IEEE80211_KEY_FLAG_SW_MGMT_TX flag to encrypt such frames in SW.
* @IEEE80211_KEY_FLAG_GENERATE_IV_MGMT: This flag should be set by the
* driver for a CCMP/GCMP key to indicate that is requires IV generation
- * only for managment frames (MFP).
+ * only for management frames (MFP).
* @IEEE80211_KEY_FLAG_RESERVE_TAILROOM: This flag should be set by the
* driver for a key to indicate that sufficient tailroom must always
* be reserved for ICV or MIC, even when HW encryption is enabled.
@@ -5198,7 +5198,7 @@ static inline int rate_supported(struct ieee80211_sta *sta,
* @sta: &struct ieee80211_sta pointer to the target destination. Note
* that this may be null.
* @priv_sta: private rate control structure. This may be null.
- * @txrc: rate control information we sholud populate for mac80211.
+ * @txrc: rate control information we should populate for mac80211.
*/
bool rate_control_send_low(struct ieee80211_sta *sta,
void *priv_sta,
@@ -133,7 +133,7 @@ enum ieee80211_agg_stop_reason {
* @buf_size: reorder buffer size at receiver
* @failed_bar_ssn: ssn of the last failed BAR tx attempt
* @bar_pending: BAR needs to be re-sent
- * @amsdu: support A-MSDU withing A-MDPU
+ * @amsdu: support A-MSDU within A-MDPU
*
* This structure's lifetime is managed by RCU, assignments to
* the array holding it must hold the aggregation mutex.
This patch fix spelling typos found in Documentation/ DocBook/80211.xml. It is because this file was generated from comments in source, so I had to fix comments in source files. Signed-off-by: Masanari Iida <standby24x7@gmail.com> --- include/net/cfg80211.h | 2 +- include/net/mac80211.h | 6 +++--- net/mac80211/sta_info.h | 2 +- 3 files changed, 5 insertions(+), 5 deletions(-)