@@ -49,7 +49,7 @@
#define SCR_FER 0xe0 /* b Function Enable */
#define SCR_MCR 0xe4 /* w Mode Control */
#define SCR_CONFIG 0xfc /* b Configuration Control */
-#define SCR_DEBUG 0xff /* b Debug */
+#define SCR_TC_DEBUG 0xff /* b Debug */
#define NAND_CFG_COMMAND 0x04 /* w Command */
#define NAND_CFG_BASE 0x10 /* l Control Base Address */
@@ -103,7 +103,7 @@ struct TC6393xbState {
uint8_t FER;
uint16_t MCR;
uint8_t CONFIG;
- uint8_t DEBUG;
+ uint8_t TC_DEBUG;
} scr;
uint32_t gpio_dir;
uint32_t gpio_level;
@@ -247,7 +247,7 @@ static uint32_t tc6393xb_scr_readb(TC6393xbState *s, target_phys_addr_t addr)
SCR_REG_B(FER);
SCR_REG_W(MCR);
SCR_REG_B(CONFIG);
- SCR_REG_B(DEBUG);
+ SCR_REG_B(TC_DEBUG);
}
fprintf(stderr, "tc6393xb_scr: unhandled read at %08x\n", (uint32_t) addr);
return 0;
@@ -308,7 +308,7 @@ static void tc6393xb_scr_writeb(TC6393xbState *s, target_phys_addr_t addr, uint3
SCR_REG_B(FER);
SCR_REG_W(MCR);
SCR_REG_B(CONFIG);
- SCR_REG_B(DEBUG);
+ SCR_REG_B(TC_DEBUG);
}
fprintf(stderr, "tc6393xb_scr: unhandled write at %08x: %02x\n",
(uint32_t) addr, value & 0xff);
Some files use DEBUG as a preprocessor conditionals to enable debug code and i find handy to pass -DDEBUG as extra cflags at configure time. Unfortunately this cannot be done if DEBUG name is used for other purposes. Signed-off-by: Riccardo Magliocchetti <riccardo.magliocchetti@gmail.com> --- hw/tc6393xb.c | 8 ++++---- 1 files changed, 4 insertions(+), 4 deletions(-)