@@ -6,7 +6,7 @@
model = "sandbox";
compatible = "sandbox";
#address-cells = <1>;
- #size-cells = <0>;
+ #size-cells = <1>;
aliases {
console = &uart0;
@@ -30,7 +30,7 @@
};
a-test {
- reg = <0>;
+ reg = <0 1>;
compatible = "denx,u-boot-fdt-test";
ping-expect = <0>;
ping-add = <0>;
@@ -43,16 +43,16 @@
};
junk {
- reg = <1>;
+ reg = <1 1>;
compatible = "not,compatible";
};
no-compatible {
- reg = <2>;
+ reg = <2 1>;
};
b-test {
- reg = <3>;
+ reg = <3 1>;
compatible = "denx,u-boot-fdt-test";
ping-expect = <3>;
ping-add = <3>;
@@ -62,7 +62,7 @@
#address-cells = <1>;
#size-cells = <0>;
compatible = "denx,u-boot-test-bus";
- reg = <3>;
+ reg = <3 1>;
ping-expect = <4>;
ping-add = <4>;
c-test@5 {
@@ -86,14 +86,14 @@
};
d-test {
- reg = <3>;
+ reg = <3 1>;
ping-expect = <6>;
ping-add = <6>;
compatible = "google,another-fdt-test";
};
e-test {
- reg = <3>;
+ reg = <3 1>;
ping-expect = <6>;
ping-add = <6>;
compatible = "google,another-fdt-test";
@@ -148,7 +148,7 @@
i2c@0 {
#address-cells = <1>;
#size-cells = <0>;
- reg = <0>;
+ reg = <0 1>;
compatible = "sandbox,i2c";
clock-frequency = <100000>;
clocks = <&clk SANDBOX_CLK_I2C>;
@@ -237,7 +237,7 @@
spi@0 {
#address-cells = <1>;
#size-cells = <0>;
- reg = <0>;
+ reg = <0 1>;
clocks = <&clk SANDBOX_CLK_SPI>;
compatible = "sandbox,spi";
cs-gpios = <0>, <&gpio_a 0>;
@@ -251,12 +251,15 @@
syscon@0 {
compatible = "sandbox,syscon0";
- reg = <0x10>;
+ reg = <0x10 4>;
};
syscon@1 {
compatible = "sandbox,syscon1";
- reg = <0x20>;
+ reg = <0x20 5
+ 0x28 6
+ 0x30 7
+ 0x38 8>;
};
uart0: serial {
Each sandbox peripheral should have a size as well as a base address. This is required for regmaps to work, so make this change for all nodes that have an address. Signed-off-by: Simon Glass <sjg@chromium.org> --- arch/sandbox/dts/test.dts | 27 +++++++++++++++------------ 1 file changed, 15 insertions(+), 12 deletions(-)