| Message ID | 1433374272-6684-16-git-send-email-jacob.e.keller@intel.com |
|---|---|
| State | Accepted |
| Delegated to: | Jeff Kirsher |
| Headers | show |
-----Original Message----- From: Intel-wired-lan [mailto:intel-wired-lan-bounces@lists.osuosl.org] On Behalf Of Jacob Keller Sent: Wednesday, June 3, 2015 4:31 PM To: Intel Wired LAN <intel-wired-lan@lists.osuosl.org> Subject: [Intel-wired-lan] [rc2 15/15] fm10k: fix iov_msg_lport_state_pf issue When a VF issues an LPORT_STATE request to enable a port that is already enabled, the PF will first disable the VF LPORT. Then it should re-enable the VF again with the new requested settings. This ensures that any switch rules are cleared by deleting the LPORT on the switch. However, the flow is bugged because we actually check if the VF is enabled at the end, and thus don't re-enable it. Fix the flow so that we actually clear the enabled flags as part of our removal of the LPORT. Signed-off-by: Jacob Keller <jacob.e.keller@intel.com> --- Tested-By: Krishneil Singh <krishneil.k.singh@intel.com>
diff --git a/drivers/net/ethernet/intel/fm10k/fm10k_pf.c b/drivers/net/ethernet/intel/fm10k/fm10k_pf.c index ab81c00327b2..54d1cd97866f 100644 --- a/drivers/net/ethernet/intel/fm10k/fm10k_pf.c +++ b/drivers/net/ethernet/intel/fm10k/fm10k_pf.c @@ -1351,6 +1351,14 @@ s32 fm10k_iov_msg_lport_state_pf(struct fm10k_hw *hw, u32 **results, err = fm10k_update_lport_state_pf(hw, vf_info->glort, 1, false); + /* we need to clear VF_FLAG_ENABLED flags in order to ensure + * that we actually re-enable the LPORT state below. Note that + * this has no impact if the VF is already disabled, as the + * flags are already cleared. + */ + if (!err) + vf_info->vf_flags = FM10K_VF_FLAG_CAPABLE(vf_info); + /* when enabling the port we should reset the rate limiters */ hw->iov.ops.configure_tc(hw, vf_info->vf_idx, vf_info->rate);
When a VF issues an LPORT_STATE request to enable a port that is already enabled, the PF will first disable the VF LPORT. Then it should re-enable the VF again with the new requested settings. This ensures that any switch rules are cleared by deleting the LPORT on the switch. However, the flow is bugged because we actually check if the VF is enabled at the end, and thus don't re-enable it. Fix the flow so that we actually clear the enabled flags as part of our removal of the LPORT. Signed-off-by: Jacob Keller <jacob.e.keller@intel.com> --- drivers/net/ethernet/intel/fm10k/fm10k_pf.c | 8 ++++++++ 1 file changed, 8 insertions(+)