@@ -856,7 +856,7 @@ static int stmmac_init_phy(struct net_device *dev)
* device as well.
* Note: phydev->phy_id is the result of reading the UID PHY registers.
*/
- if (phydev->phy_id == 0) {
+ if (!priv->plat->phy_node && phydev->phy_id == 0) {
phy_disconnect(phydev);
return -ENODEV;
}
@@ -148,6 +148,14 @@ static int stmmac_probe_config_dt(struct platform_device *pdev,
/* If we find a phy-handle property, use it as the PHY */
plat->phy_node = of_parse_phandle(np, "phy-handle", 0);
+ /* If phy-handle is not specified, check if we have a fixed-phy */
+ if (!plat->phy_node && of_phy_is_fixed_link(np)) {
+ if ((of_phy_register_fixed_link(np) < 0))
+ return -ENODEV;
+
+ plat->phy_node = of_node_get(np);
+ }
+
/* "snps,phy-addr" is not a standard property. Mark it as deprecated
* and warn of its use. Remove this when phy node support is added.
*/
@@ -212,8 +220,10 @@ static int stmmac_probe_config_dt(struct platform_device *pdev,
if (of_find_property(np, "snps,pbl", NULL)) {
dma_cfg = devm_kzalloc(&pdev->dev, sizeof(*dma_cfg),
GFP_KERNEL);
- if (!dma_cfg)
+ if (!dma_cfg) {
+ of_node_put(np);
return -ENOMEM;
+ }
plat->dma_cfg = dma_cfg;
of_property_read_u32(np, "snps,pbl", &dma_cfg->pbl);
dma_cfg->fixed_burst =
In case DT is used, this change adds the ability to the stmmac driver to detect a fixed-link PHY, instanciate it, and use it during phy_connect(). Fixed link PHYs DT usage is described in: Documentation/devicetree/bindings/net/fixed-link.txt Signed-off-by: Mathieu Olivari <mathieu@codeaurora.org> --- drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 2 +- drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 12 +++++++++++- 2 files changed, 12 insertions(+), 2 deletions(-)