diff mbox

[RFC/RFT,4/7] gpio: omap: rework omap_gpio_request to touch only gpio specific registers

Message ID 1432305354-5968-5-git-send-email-grygorii.strashko@linaro.org
State New
Headers show

Commit Message

grygorii.strashko@linaro.org May 22, 2015, 2:35 p.m. UTC 
The GPIO Chip and GPIO IRQ Chip functionality are essentially orthogonal,
so GPIO Chip implementation shouldn't touch GPIO IRQ specific registers
and vise versa.

Hence, rework omap_gpio_request:
- don't reset GPIO IRQ triggering type to IRQ_TYPE_NONE, because
  GPIO irqchip should be responsible for that;
- call directly omap_enable_gpio_module as all needed checks are already
  present inside it.

Signed-off-by: Grygorii Strashko <grygorii.strashko@linaro.org>
---
 drivers/gpio/gpio-omap.c | 9 +--------
 1 file changed, 1 insertion(+), 8 deletions(-)
diff mbox

Patch

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index d933b99..2fbd569 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -668,14 +668,7 @@  static int omap_gpio_request(struct gpio_chip *chip, unsigned offset)
 		pm_runtime_get_sync(bank->dev);
 
 	spin_lock_irqsave(&bank->lock, flags);
-	/* Set trigger to none. You need to enable the desired trigger with
-	 * request_irq() or set_irq_type(). Only do this if the IRQ line has
-	 * not already been requested.
-	 */
-	if (!LINE_USED(bank->irq_usage, offset)) {
-		omap_set_gpio_triggering(bank, offset, IRQ_TYPE_NONE);
-		omap_enable_gpio_module(bank, offset);
-	}
+	omap_enable_gpio_module(bank, offset);
 	bank->mod_usage |= BIT(offset);
 	spin_unlock_irqrestore(&bank->lock, flags);