new file mode 100644
@@ -0,0 +1,65 @@
+Broadcom STB "UPG GIO" GPIO controller
+
+The controller's registers are organized as sets of eight 32-bit
+registers with each set controlling a bank of up to 32 pins. A single
+interrupt is shared for all of the banks handled by the controller.
+
+Required properties:
+
+- compatible:
+ Must be "brcm,brcmstb-gpio"
+
+- reg:
+ Define the base and range of the I/O address space containing
+ the brcmstb GPIO controller registers
+
+- #gpio-cells:
+ Should be <2>. The first cell is the pin number (within the controller's
+ pin space), and the second is used for the following:
+ bit[0]: polarity (0 for active-high, 1 for active-low)
+
+- gpio-controller:
+ Specifies that the node is a GPIO controller.
+
+- brcm,gpio-bank-widths:
+ Number of GPIO lines for each bank. Number of elements must
+ correspond to number of banks suggested by the 'reg' property.
+
+Optional properties:
+
+- interrupts:
+ The interrupt shared by all GPIO lines for this controller.
+
+- interrupt-parent:
+ phandle of the parent interrupt controller
+
+- #interrupt-cells:
+ Should be <2>. The first cell is the GPIO number, the second should specify
+ flags. The following subset of flags is supported:
+ - bits[3:0] trigger type and level flags
+ 1 = low-to-high edge triggered
+ 2 = high-to-low edge triggered
+ 4 = active high level-sensitive
+ 8 = active low level-sensitive
+ Valid combinations are 1, 2, 3, 4, 8.
+ See also Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+
+- interrupt-controller:
+ Marks the device node as an interrupt controller
+
+- interrupt-names:
+ The name of the IRQ resource used by this controller
+
+Example:
+ upg_gio: gpio@f040a700 {
+ #gpio-cells = <0x2>;
+ #interrupt-cells = <0x2>;
+ compatible = "brcm,bcm7445-gpio", "brcm,brcmstb-gpio";
+ gpio-controller;
+ interrupt-controller;
+ reg = <0xf040a700 0x80>;
+ interrupt-parent = <0xf>;
+ interrupts = <0x6>;
+ interrupt-names = "upg_gio";
+ brcm,gpio-bank-widths = <0x20 0x20 0x20 0x18>;
+ };
Add binding for Broadcom STB "UPG GIO" GPIO controller. Signed-off-by: Gregory Fong <gregory.0xf0@gmail.com> --- .../devicetree/bindings/gpio/brcm,brcmstb-gpio.txt | 65 ++++++++++++++++++++ 1 file changed, 65 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt