diff mbox

[U-Boot,v2] net: configure DWMAC DMA by default AXI burst length

Message ID 1422508852-4451-1-git-send-email-sonic.adi@gmail.com
State Superseded
Delegated to: Tom Rini
Headers show

Commit Message

Sonic Zhang Jan. 29, 2015, 5:20 a.m. UTC 
From: Sonic Zhang <sonic.zhang@analog.com>

Board can define its own AXI burst length to improve DWMAC DMA performance.

v2-changes:
- Avoid write burst len register when the Macro is not defined.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
---
 drivers/net/designware.c |    4 ++++
 1 file changed, 4 insertions(+)
diff mbox

Patch

diff --git a/drivers/net/designware.c b/drivers/net/designware.c
index 9ded895..51eff85 100644
--- a/drivers/net/designware.c
+++ b/drivers/net/designware.c
@@ -256,6 +256,10 @@  static int dw_eth_init(struct eth_device *dev, bd_t *bis)
 
 	writel(readl(&dma_p->opmode) | RXSTART | TXSTART, &dma_p->opmode);
 
+#ifdef CONFIG_DW_AXI_BURST_LEN
+	writel((CONFIG_DW_AXI_BURST_LEN & 0x1FF >> 1), &dma_p->axibus);
+#endif
+
 	/* Start up the PHY */
 	if (phy_startup(priv->phydev)) {
 		printf("Could not initialize PHY %s\n",