@@ -45,7 +45,7 @@ config AMD8111_ETH
config LANCE
tristate "AMD LANCE and PCnet (AT1500 and NE2100) support"
- depends on ISA && ISA_DMA_API
+ depends on ISA && ISA_DMA_API && !ARM
---help---
If you have a network (Ethernet) card of this type, say Y and read
the Ethernet-HOWTO, available from
@@ -142,7 +142,7 @@ config PCMCIA_NMCLAN
config NI65
tristate "NI6510 support"
- depends on ISA && ISA_DMA_API
+ depends on ISA && ISA_DMA_API && !ARM
---help---
If you have a network (Ethernet) card of this type, say Y and read
the Ethernet-HOWTO, available from
The ni65 and lance ethernet drivers manually program the ISA DMA controller that is only available on x86 PCs and a few compatible systems. Trying to build it on ARM results in this error: ni65.c: In function 'ni65_probe1': ni65.c:496:62: error: 'DMA1_STAT_REG' undeclared (first use in this function) ((inb(DMA1_STAT_REG) >> 4) & 0x0f) ^ ni65.c:496:62: note: each undeclared identifier is reported only once for each function it appears in ni65.c:497:63: error: 'DMA2_STAT_REG' undeclared (first use in this function) | (inb(DMA2_STAT_REG) & 0xf0); The DMA1_STAT_REG and DMA2_STAT_REG registers are only defined for alpha, mips, parisc, powerpc and x86, although it is not clear which subarchitectures actually have them at the correct location. This patch for now just disables it for ARM, to avoid randconfig build errors. We could also decide to limit it to the set of architectures on which it does compile, but that might look more deliberate than guessing based on where the drivers build. Signed-off-by: Arnd Bergmann <arnd@arndb.de> --- drivers/net/ethernet/amd/Kconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)