@@ -920,12 +920,6 @@ static void sram_write(struct r8152 *tp, u16 addr, u16 data)
ocp_reg_write(tp, OCP_SRAM_DATA, data);
}
-static u16 sram_read(struct r8152 *tp, u16 addr)
-{
- ocp_reg_write(tp, OCP_SRAM_ADDR, addr);
- return ocp_reg_read(tp, OCP_SRAM_DATA);
-}
-
static int read_mii_word(struct net_device *netdev, int phy_id, int reg)
{
struct r8152 *tp = netdev_priv(netdev);
@@ -2512,24 +2506,18 @@ static void r8153_hw_phy_cfg(struct r8152 *tp)
data = ocp_reg_read(tp, OCP_POWER_CFG);
data |= EN_10M_PLLOFF;
ocp_reg_write(tp, OCP_POWER_CFG, data);
- data = sram_read(tp, SRAM_IMPEDANCE);
- data &= ~RX_DRIVING_MASK;
- sram_write(tp, SRAM_IMPEDANCE, data);
+ sram_write(tp, SRAM_IMPEDANCE, 0x0b13);
ocp_data = ocp_read_word(tp, MCU_TYPE_PLA, PLA_PHY_PWR);
ocp_data |= PFM_PWM_SWITCH;
ocp_write_word(tp, MCU_TYPE_PLA, PLA_PHY_PWR, ocp_data);
- data = sram_read(tp, SRAM_LPF_CFG);
- data |= LPF_AUTO_TUNE;
- sram_write(tp, SRAM_LPF_CFG, data);
+ /* Enable LPF corner auto tune */
+ sram_write(tp, SRAM_LPF_CFG, 0xf70f);
- data = sram_read(tp, SRAM_10M_AMP1);
- data |= GDAC_IB_UPALL;
- sram_write(tp, SRAM_10M_AMP1, data);
- data = sram_read(tp, SRAM_10M_AMP2);
- data |= AMP_DN;
- sram_write(tp, SRAM_10M_AMP2, data);
+ /* Adjust 10M Amplitude */
+ sram_write(tp, SRAM_10M_AMP1, 0x00af);
+ sram_write(tp, SRAM_10M_AMP2, 0x0208);
set_bit(PHY_RESET, &tp->flags);
}
Read OCP register 0xa43a~0xa43b would clear some flags which the hw would use, and it may let the device lost. However, the unit of reading is 4 bytes. That is, it would read 0xa438~0xa43b when calling sram_read() to read OCP_SRAM_DATA. Signed-off-by: Hayes Wang <hayeswang@realtek.com> --- drivers/net/usb/r8152.c | 24 ++++++------------------ 1 file changed, 6 insertions(+), 18 deletions(-)