Message ID | 5489E7D0.7090108@freescale.com |
---|---|
State | Superseded |
Delegated to: | Tom Rini |
Headers | show |
Tom, Hold on pulling this. Sorry I just found one patch was respined but assigned to Albert. I will send another PR after I verify it. York On 12/11/2014 10:52 AM, York Sun wrote: > Tom, > > The following changes since commit 32fdf0e4d82bdca5d64d86330e461e59685f9959: > > Prepare v2015.01-rc3 (2014-12-08 16:35:08 -0500) > > are available in the git repository at: > > git://git.denx.de/u-boot-fsl-qoriq.git master > > for you to fetch changes up to 0de15707a71ec64dbc1ead2831457f1550179ea7: > > kconfig: ls102xa: Change the prompt messages (2014-12-11 09:42:41 -0800) > > ---------------------------------------------------------------- > Alison Wang (12): > ls102xa: pblimage: Add pblimage tool support for LS102xA > spl: Use u-boot.img instead of u-boot.bin > arm: spl: Add I2C linker list in generic .lds > kconfig: ls1021a: add SUPPORT_SPL > ls102xa: qixis: Add CONFIG_QIXIS_I2C_ACCESS macro > arm: ls102xa: Add SD boot support for LS1021AQDS board > arm: ls102xa: Add SD boot support for LS1021ATWR board > arm: ls1021a: Add CONFIG_DOS_PARTITION and CONFIG_CMD_FAT support > arm: ls102xa: Fix SD/NAND/QSPI boot defination error for QE support > arm: ls102xa: Add QSPI boot support for LS1021AQDS/TWR board > arm: ls102xa: Add NAND boot support for LS1021AQDS board > kconfig: ls102xa: Change the prompt messages > > Chenhui Zhao (1): > ls1021aqds: set the default I2C channel before DDR init > > Jaiprakash Singh (1): > driver/mtd: Fix IFC compilation warnings > > Minghuan Lian (1): > arm: ls102xa: Update PCIe dts node status > > Nikhil Badola (3): > drivers: usb: Make usb device-tree fixup code architecture independent > drivers: usb: fsl: Add USB device-tree errata framework > drivers: usb: fsl: Check USB Erratum A007792 applicability > > Tang Yuantian (2): > arm: ls102xa: fixed a bus frequency setting error > fsl/sleep: updated the deep sleep framework for QorIQ platforms > > Xiubo Li (6): > ARM: HYP/non-sec: add the pen address BE mode support. > ARM: HYP/non-sec: Fix the ARCH Timer frequency setting. > ls1021a: adding a secondary core boot address and kick functions > ls102xa: changing a few targets' configurations. > ARM: ls102xa: allow all the peripheral access permission as R/W. > ARM: ls102xa: Setting device's stream id for SMMUs. > > Yao Yuan (1): > ls1021aqds: add hwconfig setting to do pin mux > > chenhui zhao (1): > arm: ls102xa: clear EPU registers for deep sleep > > Makefile | 11 +- > arch/arm/Kconfig | 6 +- > arch/arm/cpu/armv7/ls102xa/Makefile | 2 + > arch/arm/cpu/armv7/ls102xa/cpu.c | 34 +++ > arch/arm/cpu/armv7/ls102xa/fdt.c | 2 +- > arch/arm/cpu/armv7/ls102xa/fsl_epu.c | 57 ++++ > arch/arm/cpu/armv7/ls102xa/fsl_epu.h | 68 +++++ > arch/arm/cpu/armv7/ls102xa/spl.c | 33 +++ > arch/arm/cpu/armv7/nonsec_virt.S | 7 +- > arch/arm/cpu/u-boot-spl.lds | 3 + > arch/arm/include/asm/arch-ls102xa/config.h | 9 + > arch/arm/include/asm/arch-ls102xa/immap_ls102xa.h | 9 + > .../include/asm/arch-ls102xa/ls102xa_stream_id.h | 17 ++ > arch/arm/include/asm/arch-ls102xa/ns_access.h | 118 ++++++++ > arch/arm/include/asm/arch-ls102xa/spl.h | 20 ++ > arch/arm/include/asm/pcie_layerscape.h | 13 + > arch/powerpc/cpu/mpc8xxx/fdt.c | 104 ------- > board/freescale/common/Makefile | 10 + > board/freescale/common/arm_sleep.c | 95 +++++++ > board/freescale/common/ls102xa_stream_id.c | 18 ++ > board/freescale/common/mpc85xx_sleep.c | 88 ++++++ > board/freescale/common/ns_access.c | 30 +++ > board/freescale/common/qixis.h | 7 + > board/freescale/common/sleep.h | 21 ++ > board/freescale/ls1021aqds/MAINTAINERS | 3 + > board/freescale/ls1021aqds/ddr.c | 5 +- > board/freescale/ls1021aqds/ls1021aqds.c | 283 ++++++++++++++++++-- > board/freescale/ls1021aqds/ls102xa_pbi.cfg | 12 + > board/freescale/ls1021aqds/ls102xa_rcw_nand.cfg | 7 + > board/freescale/ls1021aqds/ls102xa_rcw_sd.cfg | 14 + > board/freescale/ls1021atwr/MAINTAINERS | 2 + > board/freescale/ls1021atwr/ls1021atwr.c | 151 +++++++++++ > board/freescale/ls1021atwr/ls102xa_pbi.cfg | 12 + > board/freescale/ls1021atwr/ls102xa_rcw_sd.cfg | 14 + > configs/ls1021aqds_nand_defconfig | 4 + > configs/ls1021aqds_qspi_defconfig | 3 + > configs/ls1021aqds_sdcard_defconfig | 4 + > configs/ls1021atwr_qspi_defconfig | 3 + > configs/ls1021atwr_sdcard_defconfig | 4 + > drivers/ddr/fsl/arm_ddr_gen3.c | 45 +++- > drivers/ddr/fsl/fsl_ddr_gen4.c | 44 ++- > drivers/ddr/fsl/mpc85xx_ddr_gen3.c | 67 ++--- > drivers/mtd/nand/fsl_ifc_nand.c | 2 +- > drivers/mtd/nand/fsl_ifc_spl.c | 10 + > drivers/pci/Makefile | 1 + > drivers/pci/pcie_layerscape.c | 51 ++++ > drivers/usb/host/ehci-fsl.c | 186 +++++++++++++ > include/configs/ls1021aqds.h | 175 +++++++++++- > include/configs/ls1021atwr.h | 95 ++++++- > include/configs/sun7i.h | 1 + > include/fsl_ddr_sdram.h | 12 +- > include/fsl_usb.h | 23 ++ > tools/pblimage.c | 110 +++++--- > 53 files changed, 1904 insertions(+), 221 deletions(-) > create mode 100644 arch/arm/cpu/armv7/ls102xa/fsl_epu.c > create mode 100644 arch/arm/cpu/armv7/ls102xa/fsl_epu.h > create mode 100644 arch/arm/cpu/armv7/ls102xa/spl.c > create mode 100644 arch/arm/include/asm/arch-ls102xa/ls102xa_stream_id.h > create mode 100644 arch/arm/include/asm/arch-ls102xa/ns_access.h > create mode 100644 arch/arm/include/asm/arch-ls102xa/spl.h > create mode 100644 arch/arm/include/asm/pcie_layerscape.h > create mode 100644 board/freescale/common/arm_sleep.c > create mode 100644 board/freescale/common/ls102xa_stream_id.c > create mode 100644 board/freescale/common/mpc85xx_sleep.c > create mode 100644 board/freescale/common/ns_access.c > create mode 100644 board/freescale/common/sleep.h > create mode 100644 board/freescale/ls1021aqds/ls102xa_pbi.cfg > create mode 100644 board/freescale/ls1021aqds/ls102xa_rcw_nand.cfg > create mode 100644 board/freescale/ls1021aqds/ls102xa_rcw_sd.cfg > create mode 100644 board/freescale/ls1021atwr/ls102xa_pbi.cfg > create mode 100644 board/freescale/ls1021atwr/ls102xa_rcw_sd.cfg > create mode 100644 configs/ls1021aqds_nand_defconfig > create mode 100644 configs/ls1021aqds_qspi_defconfig > create mode 100644 configs/ls1021aqds_sdcard_defconfig > create mode 100644 configs/ls1021atwr_qspi_defconfig > create mode 100644 configs/ls1021atwr_sdcard_defconfig > create mode 100644 drivers/pci/pcie_layerscape.c > > Thanks. > > York > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot >