@@ -316,6 +316,7 @@ static void set_timing_cfg_0(fsl_ddr_cfg_regs_t *ddr,
#elif defined(CONFIG_SYS_FSL_DDR3)
unsigned int data_rate = get_ddr_freq(0);
int txp;
+ unsigned int ip_rev;
/*
* (tXARD and tXARDS). Empirical?
* The DDR3 spec has not tXARD,
@@ -327,7 +328,25 @@ static void set_timing_cfg_0(fsl_ddr_cfg_regs_t *ddr,
*/
txp = max(mclk_ps * 3, (mclk_ps > 1540 ? 7500 : 6000));
- tmrd_mclk = 4;
+ ip_rev = fsl_ddr_get_version();
+ if (ip_rev >= 0x40700) {
+ /*
+ * MRS_CYC = max(tMRD, tMOD)
+ * tMRD = 4nCK (8nCK for RDIMM)
+ * tMOD = max(12nCK, 15ns)
+ */
+ tmrd_mclk = max(12, picos_to_mclk(15000));
+ } else {
+ /*
+ * MRS_CYC = tMRD
+ * tMRD = 4nCK (8nCK for RDIMM)
+ */
+ if (popts->registered_dimm_en)
+ tmrd_mclk = 8;
+ else
+ tmrd_mclk = 4;
+ }
+
/* set the turnaround time */
/*
For DDR controller version 4.7 or newer, MRC_CYC (mode register set cycle time) is max(tMRD, tMOD). tMRD is 4nCK, or 8nCK (RDIMM). tMOD is max(12nCK, 15ns) according to JEDEC spec. DDR4 is not affected by this change. Signed-off-by: York Sun <yorksun@freescale.com> --- Change log v2: Apply the change only to DDR controller newer than v4.7 Older DDRC needs to take into account of RDIMM for tMRD drivers/ddr/fsl/ctrl_regs.c | 21 ++++++++++++++++++++- 1 file changed, 20 insertions(+), 1 deletion(-)