@@ -158,7 +158,7 @@ extern void send_cleanup_vector(struct irq_cfg *);
struct irq_data;
int __ioapic_set_affinity(struct irq_data *, const struct cpumask *,
unsigned int *dest_id);
-extern int IO_APIC_get_PCI_irq_vector(int bus, int devfn, int pin, struct io_apic_irq_attr *irq_attr);
+extern int IO_APIC_get_PCI_irq_vector(int bus, int devfn, int pin);
extern void setup_ioapic_dest(void);
extern void enable_IO_APIC(void);
@@ -1179,8 +1179,7 @@ void mp_unmap_irq(int irq)
* Find a specific PCI IRQ entry.
* Not an __init, possibly needed by modules
*/
-int IO_APIC_get_PCI_irq_vector(int bus, int slot, int pin,
- struct io_apic_irq_attr *irq_attr)
+int IO_APIC_get_PCI_irq_vector(int bus, int slot, int pin)
{
int irq, i, best_ioapic = -1, best_idx = -1;
@@ -1234,14 +1233,8 @@ int IO_APIC_get_PCI_irq_vector(int bus, int slot, int pin,
return -1;
out:
- irq = pin_2_irq(best_idx, best_ioapic, mp_irqs[best_idx].dstirq,
- IOAPIC_MAP_ALLOC);
- if (irq > 0)
- set_io_apic_irq_attr(irq_attr, best_ioapic,
- mp_irqs[best_idx].dstirq,
- irq_trigger(best_idx),
- irq_polarity(best_idx));
- return irq;
+ return pin_2_irq(best_idx, best_ioapic, mp_irqs[best_idx].dstirq,
+ IOAPIC_MAP_ALLOC);
}
EXPORT_SYMBOL(IO_APIC_get_PCI_irq_vector);
@@ -1200,14 +1200,12 @@ static int pirq_enable_irq(struct pci_dev *dev)
#ifdef CONFIG_X86_IO_APIC
struct pci_dev *temp_dev;
int irq;
- struct io_apic_irq_attr irq_attr;
if (dev->irq_managed && dev->irq > 0)
return 0;
irq = IO_APIC_get_PCI_irq_vector(dev->bus->number,
- PCI_SLOT(dev->devfn),
- pin - 1, &irq_attr);
+ PCI_SLOT(dev->devfn), pin - 1);
/*
* Busses behind bridges are typically not listed in the MP-table.
* In this case we have to look up the IRQ based on the parent bus,
@@ -1221,7 +1219,7 @@ static int pirq_enable_irq(struct pci_dev *dev)
pin = pci_swizzle_interrupt_pin(dev, pin);
irq = IO_APIC_get_PCI_irq_vector(bridge->bus->number,
PCI_SLOT(bridge->devfn),
- pin - 1, &irq_attr);
+ pin - 1);
if (irq >= 0)
dev_warn(&dev->dev, "using bridge %s "
"INT %c to get IRQ %d\n",
@@ -155,13 +155,10 @@ int ibmphp_init_devno(struct slot **cur_slot)
for (loop = 0; loop < len; loop++) {
if ((*cur_slot)->number == rtable->slots[loop].slot &&
(*cur_slot)->bus == rtable->slots[loop].bus) {
- struct io_apic_irq_attr irq_attr;
-
(*cur_slot)->device = PCI_SLOT(rtable->slots[loop].devfn);
for (i = 0; i < 4; i++)
(*cur_slot)->irq[i] = IO_APIC_get_PCI_irq_vector((int) (*cur_slot)->bus,
- (int) (*cur_slot)->device, i,
- &irq_attr);
+ (int) (*cur_slot)->device, i);
debug("(*cur_slot)->irq[0] = %x\n",
(*cur_slot)->irq[0]);
Now the fourth parameter of IO_APIC_get_PCI_irq_vector() is useless, so kill it. Assume it's only used by ibmphp PCI hotplug driver though IO_APIC_get_PCI_irq_vector() has been exported, Signed-off-by: Jiang Liu <jiang.liu@linux.intel.com> --- arch/x86/include/asm/hw_irq.h | 2 +- arch/x86/kernel/apic/io_apic.c | 13 +++---------- arch/x86/pci/irq.c | 6 ++---- drivers/pci/hotplug/ibmphp_core.c | 5 +---- 4 files changed, 7 insertions(+), 19 deletions(-)