@@ -124,20 +124,18 @@ static int xgene_enet_ecc_init(struct xgene_enet_pdata *p)
{
struct net_device *ndev = p->ndev;
u32 data;
- int i;
+ int i = 0;
xgene_enet_wr_diag_csr(p, ENET_CFG_MEM_RAM_SHUTDOWN_ADDR, 0);
- for (i = 0; i < 10 && data != ~0U ; i++) {
+ do {
usleep_range(100, 110);
data = xgene_enet_rd_diag_csr(p, ENET_BLOCK_MEM_RDY_ADDR);
- }
+ if (data == ~0U)
+ return 0;
+ } while (++i < 10);
- if (data != ~0U) {
- netdev_err(ndev, "Failed to release memory from shutdown\n");
- return -ENODEV;
- }
-
- return 0;
+ netdev_err(ndev, "Failed to release memory from shutdown\n");
+ return -ENODEV;
}
static void xgene_enet_config_ring_if_assoc(struct xgene_enet_pdata *p)
drivers/net/ethernet/apm/xgene/xgene_enet_sgmac.c: In function ‘xgene_enet_ecc_init’: drivers/net/ethernet/apm/xgene/xgene_enet_sgmac.c:126: warning: ‘data’ may be used uninitialized in this function Depending on the arbitrary value on the stack, the loop may terminate too early, and cause a bogus -ENODEV failure. Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org> --- v3: - Use "do { ... } while (...);" instead of "for (...) { ... }", v2: - Rewrite the loop instead of pre-initializing data. drivers/net/ethernet/apm/xgene/xgene_enet_sgmac.c | 16 +++++++--------- 1 file changed, 7 insertions(+), 9 deletions(-)