@@ -3594,6 +3594,8 @@ static bool find_full_id_nand(struct mtd_info *mtd, struct nand_chip *chip,
chip->options |= type->options;
chip->ecc_strength_ds = NAND_ECC_STRENGTH(type);
chip->ecc_step_ds = NAND_ECC_STEP(type);
+ chip->onfi_timing_mode_default =
+ type->onfi_timing_mode_default;
*busw = type->options & NAND_BUSWIDTH_16;
@@ -587,6 +587,11 @@ struct nand_buffers {
* @ecc_step_ds: [INTERN] ECC step required by the @ecc_strength_ds,
* also from the datasheet. It is the recommended ECC step
* size, if known; if unknown, set to zero.
+ * @onfi_timing_mode_default: [INTERN] default ONFI timing mode. This field is
+ * either deduced from the datasheet if the NAND
+ * chip is not ONFI compliant or set to 0 if it is
+ * (an ONFI chip is always configured in mode 0
+ * after a NAND reset)
* @numchips: [INTERN] number of physical chips
* @chipsize: [INTERN] the size of one chip for multichip arrays
* @pagemask: [INTERN] page number mask = number of (pages / chip) - 1
@@ -671,6 +676,7 @@ struct nand_chip {
uint8_t bits_per_cell;
uint16_t ecc_strength_ds;
uint16_t ecc_step_ds;
+ int onfi_timing_mode_default;
int badblockpos;
int badblockbits;
@@ -773,6 +779,10 @@ struct nand_chip {
* @ecc_step_ds in nand_chip{}, also from the datasheet.
* For example, the "4bit ECC for each 512Byte" can be set with
* NAND_ECC_INFO(4, 512).
+ * @onfi_timing_mode_default: the default ONFI timing mode entered after a NAND
+ * reset. Should be deduced from timings described
+ * in the datasheet.
+ *
*/
struct nand_flash_dev {
char *name;
@@ -793,6 +803,7 @@ struct nand_flash_dev {
uint16_t strength_ds;
uint16_t step_ds;
} ecc;
+ int onfi_timing_mode_default;
};
/**
Add an onfi_timing_mode_default field to nand_chip and nand_flash_dev in order to support NAND timings definition for non-ONFI NAND. NAND that support better timings mode than the default one have to define a new entry in the nand_ids table. The default timing mode should be deduced from timings description from the datasheet and the ONFI specification (www.onfi.org/~/media/ONFI/specs/onfi_3_1_spec.pdf, chapter 4.15 "Timing Parameters"). You should choose the closest mode that fit the timings requirements of your NAND chip. Signed-off-by: Boris BREZILLON <boris.brezillon@free-electrons.com> --- drivers/mtd/nand/nand_base.c | 2 ++ include/linux/mtd/nand.h | 11 +++++++++++ 2 files changed, 13 insertions(+)