@@ -37,6 +37,8 @@
* dat_bit_offset: Offset (in bits) to the first GPIO bit.
* dir_bit_offset: Optional offset (in bits) to the first bit to switch
* GPIO direction (Used with GPIO_SYSCON_FEAT_DIR flag).
+ * set: HW specific callback to assigns output value
+ * for signal "offset"
*/
struct syscon_gpio_data {
@@ -45,6 +47,8 @@ struct syscon_gpio_data {
unsigned int bit_count;
unsigned int dat_bit_offset;
unsigned int dir_bit_offset;
+ void (*set)(struct gpio_chip *chip,
+ unsigned offset, int value);
};
struct syscon_gpio_priv {
@@ -111,7 +115,7 @@ static int syscon_gpio_dir_out(struct gpio_chip *chip, unsigned offset, int val)
BIT(offs % SYSCON_REG_BITS));
}
- syscon_gpio_set(chip, offset, val);
+ priv->data->set(chip, offset, val);
return 0;
}
@@ -159,7 +163,7 @@ static int syscon_gpio_probe(struct platform_device *pdev)
if (priv->data->flags & GPIO_SYSCON_FEAT_IN)
priv->chip.direction_input = syscon_gpio_dir_in;
if (priv->data->flags & GPIO_SYSCON_FEAT_OUT) {
- priv->chip.set = syscon_gpio_set;
+ priv->chip.set = priv->data->set ? : syscon_gpio_set;
priv->chip.direction_output = syscon_gpio_dir_out;
}
Some SoCs (like Keystone) may require to perform special sequence of operations to assign output GPIO value, so default implementation of .set() callback from gpio-syscon driver can't be used. Hence, add optional, SoC specific callback to assign output gpio value. Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com> --- drivers/gpio/gpio-syscon.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)