@@ -136,7 +136,7 @@ int qlcnic_82xx_issue_cmd(struct qlcnic_adapter *adapter,
rsp = qlcnic_poll_rsp(adapter);
if (rsp == QLCNIC_CDRP_RSP_TIMEOUT) {
- dev_err(&pdev->dev, "card response timeout.\n");
+ dev_err(&pdev->dev, "command timeout, response = 0x%x\n", rsp);
cmd->rsp.arg[0] = QLCNIC_RCODE_TIMEOUT;
} else if (rsp == QLCNIC_CDRP_RSP_FAIL) {
cmd->rsp.arg[0] = QLCRD32(adapter, QLCNIC_CDRP_ARG(1), &err);
@@ -2623,13 +2623,13 @@ qlcnic_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
if (err)
goto err_out_disable_mbx_intr;
+ if (adapter->portnum == 0)
+ qlcnic_set_drv_version(adapter);
+
err = qlcnic_setup_netdev(adapter, netdev, pci_using_dac);
if (err)
goto err_out_disable_mbx_intr;
- if (adapter->portnum == 0)
- qlcnic_set_drv_version(adapter);
-
pci_set_drvdata(pdev, adapter);
if (qlcnic_82xx_check(adapter))
o Earlier, set_drv_version was getting called after register_netdev. This was resulting in a race between set_drv_version and FLR called from open(). Moving set_drv_version before register_netdev avoids the race. o Log response code in error message on CDRP failure. Signed-off-by: Rajesh Borundia <rajesh.borundia@qlogic.com> --- drivers/net/ethernet/qlogic/qlcnic/qlcnic_ctx.c | 2 +- drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-)