@@ -787,8 +787,7 @@ static void sky2_set_tx_stfwd(struct sky
if ( (hw->chip_id == CHIP_ID_YUKON_EX &&
hw->chip_rev != CHIP_REV_YU_EX_A0) ||
- hw->chip_id == CHIP_ID_YUKON_FE_P ||
- hw->chip_id == CHIP_ID_YUKON_SUPR) {
+ hw->chip_id >= CHIP_ID_YUKON_FE_P) {
/* Yukon-Extreme B0 and further Extreme devices */
/* enable Store & Forward mode for TX */
@@ -1404,6 +1403,31 @@ static int sky2_rx_start(struct sky2_por
/* Tell chip about available buffers */
sky2_rx_update(sky2, rxq);
+
+ if (hw->chip_id == CHIP_ID_YUKON_EX ||
+ hw->chip_id == CHIP_ID_YUKON_SUPR) {
+ /*
+ * Disable flushing of non ASF packets;
+ * must be done after initializing the BMUs;
+ * drivers without ASF support should do this too, otherwise
+ * it may happen that they cannot run on ASF devices;
+ * remember that the MAC FIFO isn't reset during initialization.
+ */
+ sky2_write32(hw, SK_REG(sky2->port, RX_GMF_CTRL_T), RX_MACSEC_FLUSH_OFF);
+ }
+
+ if (hw->chip_id >= CHIP_ID_YUKON_SUPR) {
+ /* Enable RX Home Address & Routing Header checksum fix */
+ sky2_write16(hw, SK_REG(sky2->port, RX_GMF_FL_CTRL),
+ RX_IPV6_SA_MOB_ENA | RX_IPV6_DA_MOB_ENA);
+
+ /* Enable TX Home Address & Routing Header checksum fix */
+ sky2_write32(hw, Q_ADDR(txqaddr[sky2->port], Q_TEST),
+ TBMU_TEST_HOME_ADD_FIX_EN | TBMU_TEST_ROUTING_ADD_FIX_EN);
+ }
+
+
+
return 0;
nomem:
sky2_rx_clean(sky2);
@@ -2993,6 +3017,12 @@ static void sky2_reset(struct sky2_hw *h
sky2_write16(hw, SK_REG(i, GMAC_CTRL),
GMC_BYP_MACSECRX_ON | GMC_BYP_MACSECTX_ON
| GMC_BYP_RETR_ON);
+
+ }
+
+ if (hw->chip_id == CHIP_ID_YUKON_SUPR && hw->chip_rev > CHIP_REV_YU_SU_B0) {
+ /* enable MACSec clock gating */
+ sky2_pci_write32(hw, PCI_DEV_REG3, P_CLK_MACSEC_DIS);
}
/* Clear I2C IRQ noise */
Changes related to support of Yukon supreme chip. Don't have this chip version to test on, these are reverse engineered from the vendor (GPL) driver. Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>