@@ -331,16 +331,6 @@ static int xgbe_set_settings(struct net_device *netdev,
(cmd->duplex != DUPLEX_FULL)))
goto unlock;
- if (cmd->autoneg == AUTONEG_ENABLE) {
- /* Clear settings needed to force speeds */
- phydev->supported &= ~SUPPORTED_1000baseT_Full;
- phydev->supported &= ~SUPPORTED_10000baseT_Full;
- } else {
- /* Add settings needed to force speed */
- phydev->supported |= SUPPORTED_1000baseT_Full;
- phydev->supported |= SUPPORTED_10000baseT_Full;
- }
-
cmd->advertising &= phydev->supported;
if ((cmd->autoneg == AUTONEG_ENABLE) && !cmd->advertising)
goto unlock;
@@ -375,10 +375,6 @@ int xgbe_mdio_register(struct xgbe_prv_data *pdata)
phydev->autoneg = pdata->default_autoneg;
if (phydev->autoneg == AUTONEG_DISABLE) {
- /* Add settings needed to force speed */
- phydev->supported |= SUPPORTED_1000baseT_Full;
- phydev->supported |= SUPPORTED_10000baseT_Full;
-
phydev->speed = pdata->default_speed;
phydev->duplex = DUPLEX_FULL;
With the addition of entries in the phy speed/duplex settings array to support KR and KX mode, the work-around to add/remove baseT settings to run at a fixed speed is no longer needed. Signed-off-by: Tom Lendacky <thomas.lendacky@amd.com> --- drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c | 10 ---------- drivers/net/ethernet/amd/xgbe/xgbe-mdio.c | 4 ---- 2 files changed, 14 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html