@@ -249,7 +249,7 @@ static int dw_eth_init(struct eth_device *dev, bd_t *bis)
rx_descs_init(dev);
tx_descs_init(dev);
- writel(FIXEDBURST | PRIORXTX_41 | BURST_16, &dma_p->busmode);
+ writel(FIXEDBURST | PRIORXTX_41 | DMA_PBL, &dma_p->busmode);
writel(readl(&dma_p->opmode) | FLUSHTXFIFO | STOREFORWARD,
&dma_p->opmode);
@@ -77,18 +77,18 @@ struct eth_dma_regs {
#define DW_DMA_BASE_OFFSET (0x1000)
+/* Default DMA Burst length */
+#ifndef CONFIG_DW_GMAC_DEFAULT_DMA_PBL
+#define CONFIG_DW_GMAC_DEFAULT_DMA_PBL 8
+#endif
+
/* Bus mode register definitions */
#define FIXEDBURST (1 << 16)
#define PRIORXTX_41 (3 << 14)
#define PRIORXTX_31 (2 << 14)
#define PRIORXTX_21 (1 << 14)
#define PRIORXTX_11 (0 << 14)
-#define BURST_1 (1 << 8)
-#define BURST_2 (2 << 8)
-#define BURST_4 (4 << 8)
-#define BURST_8 (8 << 8)
-#define BURST_16 (16 << 8)
-#define BURST_32 (32 << 8)
+#define DMA_PBL (CONFIG_DW_GMAC_DEFAULT_DMA_PBL<<8)
#define RXHIGHPRIO (1 << 1)
#define DMAMAC_SRST (1 << 0)
The correct value for this setting can vary across SoCs and boards, so make it configurable. Also reduce the default value to 8, which is the same default as used in the Linux driver. Signed-off-by: Ian Campbell <ijc@hellion.org.uk> Cc: Alexey Brodkin <abrodkin@synopsys.com> --- v3: Pulled into this series instead of sunxi series. --- drivers/net/designware.c | 2 +- drivers/net/designware.h | 12 ++++++------ 2 files changed, 7 insertions(+), 7 deletions(-)