diff mbox

[U-Boot,1/2] net: zynq: Use predefined macros instead of hardcoded value

Message ID b6e2d9ca349ff0f8c30855b85e1f323d1e8a3dc3.1398433511.git.michal.simek@xilinx.com
State Accepted
Delegated to: Michal Simek
Headers show

Commit Message

Michal Simek April 25, 2014, 1:45 p.m. UTC 
MII is used by this driver.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

 drivers/net/zynq_gem.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

--
1.8.2.3
diff mbox

Patch

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 101489c..08056a4 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -338,7 +338,8 @@  static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
 	phy_detection(dev);

 	/* interface - look at tsec */
-	phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0);
+	phydev = phy_connect(priv->bus, priv->phyaddr, dev,
+			     PHY_INTERFACE_MODE_MII);

 	phydev->supported = supported | ADVERTISED_Pause |
 			    ADVERTISED_Asym_Pause;