@@ -2343,9 +2343,15 @@ bnx2_init_copper_phy(struct bnx2 *bp, int reset_phy)
}
/* ethernet@wirespeed */
- bnx2_write_phy(bp, 0x18, 0x7007);
- bnx2_read_phy(bp, 0x18, &val);
- bnx2_write_phy(bp, 0x18, val | (1 << 15) | (1 << 4));
+ bnx2_write_phy(bp, MII_BNX2_AUX_CTL, AUX_CTL_MISC_CTL);
+ bnx2_read_phy(bp, MII_BNX2_AUX_CTL, &val);
+ val |= AUX_CTL_MISC_CTL_WR | AUX_CTL_MISC_CTL_WIRESPEED;
+
+ /* auto-mdix */
+ if (BNX2_CHIP(bp) == BNX2_CHIP_5709)
+ val |= AUX_CTL_MISC_CTL_AUTOMDIX;
+
+ bnx2_write_phy(bp, MII_BNX2_AUX_CTL, val);
return 0;
}
@@ -6471,6 +6471,12 @@ struct l2_fhdr {
#define BCM5708S_TX_ACTL3 0x17
+#define MII_BNX2_AUX_CTL 0x18
+#define AUX_CTL_MISC_CTL 0x7007
+#define AUX_CTL_MISC_CTL_WIRESPEED (1 << 4)
+#define AUX_CTL_MISC_CTL_AUTOMDIX (1 << 9)
+#define AUX_CTL_MISC_CTL_WR (1 << 15)
+
#define MII_BNX2_DSP_RW_PORT 0x15
#define MII_BNX2_DSP_ADDRESS 0x17
#define MII_BNX2_DSP_EXPAND_REG 0x0f00
Auto-mdix currently only works if autoneg is enabled. This patch enables auto-mdix all the time by setting a bit in a PHY register. Define meaningful constants for this PHY registers. Signed-off-by: Michael Chan <mchan@broadcom.com> --- drivers/net/ethernet/broadcom/bnx2.c | 12 +++++++++--- drivers/net/ethernet/broadcom/bnx2.h | 6 ++++++ 2 files changed, 15 insertions(+), 3 deletions(-)