@@ -2161,6 +2161,20 @@ static void ftdi_set_termios(struct tty_struct *tty,
termios->c_cflag |= CRTSCTS;
}
+ /*
+ * All FTDI UART chips are limited to CS7/8. We won't pretend to
+ * support CS5/6 and revert the CSIZE setting instead.
+ */
+ if ((C_CSIZE(tty) != CS8) && (C_CSIZE(tty) != CS7)) {
+ dev_warn(&port->dev, "requested CSIZE setting not supported\n");
+
+ termios->c_cflag &= ~CSIZE;
+ if (old_termios)
+ termios->c_cflag |= old_termios->c_cflag & CSIZE;
+ else
+ termios->c_cflag |= CS8;
+ }
+
cflag = termios->c_cflag;
if (!old_termios)
@@ -2197,13 +2211,16 @@ no_skip:
} else {
urb_value |= FTDI_SIO_SET_DATA_PARITY_NONE;
}
- if (cflag & CSIZE) {
- switch (cflag & CSIZE) {
- case CS7: urb_value |= 7; dbg("Setting CS7"); break;
- case CS8: urb_value |= 8; dbg("Setting CS8"); break;
- default:
- dev_err(&port->dev, "CSIZE was set but not CS7-CS8\n");
- }
+ switch (cflag & CSIZE) {
+ case CS7:
+ urb_value |= 7;
+ dbg("Setting CS7\n");
+ break;
+ default:
+ case CS8:
+ urb_value |= 8;
+ dbg("Setting CS8\n");
+ break;
}
/* This is needed by the break command since it uses the same command