@@ -66,6 +66,8 @@
/* Used for Spansion flashes only. */
#define OPCODE_BRWR 0x17 /* Bank register write */
+#define OPCODE_DP 0xb9 /* Enter deep power down mode */
+#define OPCODE_RES 0xab /* Exit deep power down mode */
/* Status Register bits. */
#define SR_WIP 1 /* Write in progress */
@@ -1128,11 +1130,46 @@ static int m25p_remove(struct spi_device *spi)
return mtd_device_unregister(&flash->mtd);
}
+#ifdef CONFIG_PM_SLEEP
+static int m25p_suspend(struct device *dev)
+{
+ struct m25p *flash = dev_get_drvdata(dev);
+ int ret;
+
+ flash->command[0] = OPCODE_DP;
+ mutex_lock(&flash->lock);
+ /* Wait until finished previous write/erase command. */
+ ret = wait_till_ready(flash);
+ if (ret) {
+ mutex_unlock(&flash->lock);
+ return ret;
+ }
+ ret = spi_write(flash->spi, flash->command, 1);
+ mutex_unlock(&flash->lock);
+
+ return ret;
+}
+
+static int m25p_resume(struct device *dev)
+{
+ struct m25p *flash = dev_get_drvdata(dev);
+ int ret;
+
+ flash->command[0] = OPCODE_RES;
+
+ return spi_write(flash->spi, flash->command, 1);
+}
+#endif /* CONFIG_PM_SLEEP */
+
+static const struct dev_pm_ops m25p_pm = {
+ SET_SYSTEM_SLEEP_PM_OPS(m25p_suspend, m25p_resume)
+};
static struct spi_driver m25p80_driver = {
.driver = {
.name = "m25p80",
.owner = THIS_MODULE,
+ .pm = &m25p_pm,
},
.id_table = m25p_ids,
.probe = m25p_probe,
Add PM support using callback function suspend and resume in .driver.pm of spi_driver. Signed-off-by: Hou Zhiqiang <b48286@freescale.com> --- v2: - Replace .driver.suspend and .driver.resume with .driver.pm - Use CONFIG_PM_SLEEP instead of CONFIG_PM drivers/mtd/devices/m25p80.c | 37 +++++++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+)