[4/9] ARM: dts: omap5-uevm: update LDO1 voltage to 1.5V and settings

Message ID 1374079538-19548-5-git-send-email-nm@ti.com
State New
Headers show

Commit Message

Nishanth Menon July 17, 2013, 4:45 p.m.
commit e00c27ef3b4c23e39d0a77b7c8e5be44c28001c7
(ARM: dts: OMAP5: Add Palmas MFD node and regulator nodes)
introduced regulator entries for OMAP5uEVM.

However, The regulator information is based on an older temporary
pre-production board variant and does not reflect production board
750-2628-XXX boards.

LDO1 supplies VDDAPHY_CAM which is OMAP5's vdda_csiporta/b/c. This
can only be supplied at 1.5V or 1.8V and we currently supply 2.8V.

To prevent any potential device damage risk, use the specified
1.5V-1.8V supply.

Remove 'always-on' and 'boot-on' settings here as it is
a 'on need' supply to SoC IP and is not enabled by PMIC by
default at boot.

Reported-by: Marc J├╝ttner <m-juettner@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
 arch/arm/boot/dts/omap5-uevm.dts |    6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)


diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
index 87b3e9e..a55f4d8 100644
--- a/arch/arm/boot/dts/omap5-uevm.dts
+++ b/arch/arm/boot/dts/omap5-uevm.dts
@@ -346,10 +346,8 @@ 
 				ldo1_reg: ldo1 {
 					/* VDDAPHY_CAM: vdda_csiport */
 					regulator-name = "ldo1";
-					regulator-min-microvolt = <2800000>;
-					regulator-max-microvolt = <2800000>;
-					regulator-always-on;
-					regulator-boot-on;
+					regulator-min-microvolt = <1500000>;
+					regulator-max-microvolt = <1800000>;
 				ldo2_reg: ldo2 {