@@ -150,6 +150,7 @@
#define CONFIG_CMD_CACHE
#define CONFIG_CMD_EXT2 /* EXT2 Support */
#define CONFIG_CMD_FAT /* FAT support */
+#define CONFIG_CMD_FS_GENERIC /* Generic FS support */
#define CONFIG_CMD_MTDPARTS /* Enable MTD parts commands */
#define CONFIG_MTD_DEVICE /* needed for mtdparts commands */
#define MTDIDS_DEFAULT "nand0=nand"
@@ -211,6 +212,9 @@
"rdaddr=0x81000000\0" \
"usbtty=cdc_acm\0" \
"bootfile=uImage\0" \
+ "ramdisk=ramdisk.gz\0" \
+ "bootdir=/boot\0" \
+ "bootpart=0:2\0" \
"console=ttyO2,115200n8\0" \
"mpurate=auto\0" \
"buddy=none\0" \
@@ -259,9 +263,8 @@
"omapdss.def_disp=${defaultdisplay} " \
"root=${ramroot} " \
"rootfstype=${ramrootfstype}\0" \
- "loadramdisk=fatload mmc ${mmcdev} ${rdaddr} ramdisk.gz\0" \
- "loaduimagefat=fatload mmc ${mmcdev} ${loadaddr} uImage\0" \
- "loaduimage=ext2load mmc ${mmcdev}:2 ${loadaddr} /boot/uImage\0" \
+ "loadramdisk=load mmc ${bootpart} ${rdaddr} ${bootdir}/${ramdisk}\0" \
+ "loadimage=load mmc ${bootpart} ${loadaddr} ${bootdir}/${bootfile}\0" \
"mmcboot=echo Booting from mmc ...; " \
"run mmcargs; " \
"bootm ${loadaddr}\0" \
@@ -293,7 +296,7 @@
"echo Running uenvcmd ...;" \
"run uenvcmd;" \
"fi;" \
- "if run loaduimage; then " \
+ "if run loadimage; then " \
"run mmcboot;" \
"fi;" \
"fi;" \
CMD_FS_GENERIC allows us to simplify where we load up our image from either from ext2/fat etc. So, lets use that instead of cumbersome options we currently use. Sticking with existing conventions, defaults will be: ramdisk=ramdisk.gz bootpart=0:2 (second partition) bootdir=/boot (/boot in second partition) This matches with the default behavior, these can be overriden by env files as needed. Signed-off-by: Nishanth Menon <nm@ti.com> --- include/configs/omap3_beagle.h | 11 +++++++---- 1 file changed, 7 insertions(+), 4 deletions(-)