@@ -226,10 +226,6 @@ endif
- select MTD_DOCECC
bool "Advanced detection options for DiskOnChip"
@@ -240,23 +236,6 @@ config MTD_DOCPROBE_ADVANCED
are unlikely to need any of this unless you are using LinuxBIOS.
- hex "Physical address of DiskOnChip" if MTD_DOCPROBE_ADVANCED
- depends on MTD_DOCPROBE
- default "0x0"
- By default, the probe for DiskOnChip devices will look for a
- DiskOnChip at every multiple of 0x2000 between 0xC8000 and 0xEE000.
- This option allows you to specify a single address at which to probe
- for the device, which is useful if you have other devices in that
- range which get upset when they are probed.
- (Note that on PowerPC, the normal probe will only check at
- Normally, you should leave this set to zero, to allow the probe at
- the normal addresses.
bool "Probe high addresses"
depends on MTD_DOCPROBE_ADVANCED
@@ -267,16 +246,4 @@ config MTD_DOCPROBE_HIGH
0xFFFEE000. Unless you are using LinuxBIOS, this is unlikely to be
useful to you. Say 'N'.
- bool "Probe for 0x55 0xAA BIOS Extension Signature"
- depends on MTD_DOCPROBE_ADVANCED
- Check for the 0x55 0xAA signature of a DiskOnChip, and do not
- continue with probing if it is absent. The signature will always be
- present for a DiskOnChip 2000 or a normal DiskOnChip Millennium.
- Only if you have overwritten the first block of a DiskOnChip
- Millennium will it be absent. Enable this option if you are using
- LinuxBIOS or if you need to recover a DiskOnChip Millennium on which
- you have managed to wipe the first block.