Patchwork [2/3] i2c: mxs: remove races in PIO code

login
register
mail settings
Submitter Lucas Stach
Date March 14, 2013, 11:49 a.m.
Message ID <1363261750-26645-2-git-send-email-l.stach@pengutronix.de>
Download mbox | patch
Permalink /patch/227632/
State Superseded
Headers show

Comments

Lucas Stach - March 14, 2013, 11:49 a.m.
This commit fixes the three following races in PIO code:

- The CTRL0 register is racy in itself, when programming transfer state and
  run bit in the same cycle the hardware sometimes ends up using the state
  from the last transfer. Fix this by programming state in one cycle, make
  sure the write is flushed down APBX bus by reading back the reg and only
  then trigger the run bit.

- Only clear the DMAREQ bit in DEBUG0 after the read/write to the data reg
  happened. Otherwise we are racing with the hardware about who touches
  the data reg first.

- When checking for completion of a transfer it's not sufficient to check
  if the data engine finished, but also a check for i2c bus idle is needed.
  In PIO mode we are really fast to program the next transfer after a finished
  one, so the controller possibly tries to start a new transfer while the
  clkgen engine is still busy writing the NAK/STOP from the last transfer to
  the bus.

Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
---
 drivers/i2c/busses/i2c-mxs.c |   56 ++++++++++++++++++++++++++++++++----------
 1 file changed, 43 insertions(+), 13 deletions(-)
Marek Vasut - April 1, 2013, 10:58 p.m.
Dear Lucas Stach,

sorry for the delay, I'm totalled ... well, trying to make it through the queue 
now.

CC Fabio on MXS patches please.

[...]

> -static int mxs_i2c_pio_wait_cplt(struct mxs_i2c_dev *i2c)
> +static int mxs_i2c_pio_wait_cplt(struct mxs_i2c_dev *i2c, int last)

You can use bool instead of int here and then use "true"/"false" below.

Best regards,
Marek Vasut
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Patch

diff --git a/drivers/i2c/busses/i2c-mxs.c b/drivers/i2c/busses/i2c-mxs.c
index f9704b2..e8f07dc 100644
--- a/drivers/i2c/busses/i2c-mxs.c
+++ b/drivers/i2c/busses/i2c-mxs.c
@@ -65,6 +65,10 @@ 
 #define MXS_I2C_CTRL1_SLAVE_STOP_IRQ		0x02
 #define MXS_I2C_CTRL1_SLAVE_IRQ			0x01
 
+#define MXS_I2C_STAT		(0x50)
+#define MXS_I2C_STAT_BUS_BUSY			0x00000800
+#define MXS_I2C_STAT_CLK_GEN_BUSY		0x00000400
+
 #define MXS_I2C_DATA		(0xa0)
 
 #define MXS_I2C_DEBUG0		(0xb0)
@@ -298,12 +302,10 @@  static int mxs_i2c_pio_wait_dmareq(struct mxs_i2c_dev *i2c)
 		cond_resched();
 	}
 
-	writel(MXS_I2C_DEBUG0_DMAREQ, i2c->regs + MXS_I2C_DEBUG0_CLR);
-
 	return 0;
 }
 
-static int mxs_i2c_pio_wait_cplt(struct mxs_i2c_dev *i2c)
+static int mxs_i2c_pio_wait_cplt(struct mxs_i2c_dev *i2c, int last)
 {
 	unsigned long timeout = jiffies + msecs_to_jiffies(1000);
 
@@ -324,9 +326,33 @@  static int mxs_i2c_pio_wait_cplt(struct mxs_i2c_dev *i2c)
 	writel(MXS_I2C_CTRL1_DATA_ENGINE_CMPLT_IRQ,
 		i2c->regs + MXS_I2C_CTRL1_CLR);
 
+	/*
+	 * When ending a transfer with a stop, we have to wait for the bus to
+	 * go idle before we report the transfer as completed. Otherwise the
+	 * start of the next transfer may race with the end of the current one.
+	 */
+	while (last && (readl(i2c->regs + MXS_I2C_STAT) &
+			(MXS_I2C_STAT_BUS_BUSY | MXS_I2C_STAT_CLK_GEN_BUSY))) {
+		if (time_after(jiffies, timeout))
+			return -ETIMEDOUT;
+		cond_resched();
+	}
+
 	return 0;
 }
 
+static void mxs_i2c_pio_trigger_cmd(struct mxs_i2c_dev *i2c, u32 cmd)
+{
+	u32 reg;
+
+	writel(cmd, i2c->regs + MXS_I2C_CTRL0);
+
+	/* readback makes sure the write is latched into hardware */
+	reg = readl(i2c->regs + MXS_I2C_CTRL0);
+	reg |= MXS_I2C_CTRL0_RUN;
+	writel(reg, i2c->regs + MXS_I2C_CTRL0);
+}
+
 static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 {
 	struct mxs_i2c_dev *i2c = i2c_get_adapdata(adap);
@@ -341,23 +367,22 @@  static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 		addr_data |= I2C_SMBUS_READ;
 
 		/* SELECT command. */
-		writel(MXS_I2C_CTRL0_RUN | MXS_CMD_I2C_SELECT,
-			i2c->regs + MXS_I2C_CTRL0);
+		mxs_i2c_pio_trigger_cmd(i2c, MXS_CMD_I2C_SELECT);
 
 		ret = mxs_i2c_pio_wait_dmareq(i2c);
 		if (ret)
 			return ret;
 
 		writel(addr_data, i2c->regs + MXS_I2C_DATA);
+		writel(MXS_I2C_DEBUG0_DMAREQ, i2c->regs + MXS_I2C_DEBUG0_CLR);
 
-		ret = mxs_i2c_pio_wait_cplt(i2c);
+		ret = mxs_i2c_pio_wait_cplt(i2c, 0);
 		if (ret)
 			return ret;
 
 		/* READ command. */
-		writel(MXS_I2C_CTRL0_RUN | MXS_CMD_I2C_READ |
-			MXS_I2C_CTRL0_XFER_COUNT(msg->len),
-			i2c->regs + MXS_I2C_CTRL0);
+		mxs_i2c_pio_trigger_cmd(i2c, MXS_CMD_I2C_READ |
+					MXS_I2C_CTRL0_XFER_COUNT(msg->len));
 
 		for (i = 0; i < msg->len; i++) {
 			if ((i & 3) == 0) {
@@ -365,6 +390,8 @@  static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 				if (ret)
 					return ret;
 				data = readl(i2c->regs + MXS_I2C_DATA);
+				writel(MXS_I2C_DEBUG0_DMAREQ,
+				       i2c->regs + MXS_I2C_DEBUG0_CLR);
 			}
 			msg->buf[i] = data & 0xff;
 			data >>= 8;
@@ -373,9 +400,8 @@  static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 		addr_data |= I2C_SMBUS_WRITE;
 
 		/* WRITE command. */
-		writel(MXS_I2C_CTRL0_RUN | MXS_CMD_I2C_WRITE |
-			MXS_I2C_CTRL0_XFER_COUNT(msg->len + 1),
-			i2c->regs + MXS_I2C_CTRL0);
+		mxs_i2c_pio_trigger_cmd(i2c, MXS_CMD_I2C_WRITE |
+					MXS_I2C_CTRL0_XFER_COUNT(msg->len + 1));
 
 		/*
 		 * The LSB of data buffer is the first byte blasted across
@@ -391,6 +417,8 @@  static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 				if (ret)
 					return ret;
 				writel(data, i2c->regs + MXS_I2C_DATA);
+				writel(MXS_I2C_DEBUG0_DMAREQ,
+				       i2c->regs + MXS_I2C_DEBUG0_CLR);
 			}
 		}
 
@@ -401,10 +429,12 @@  static int mxs_i2c_pio_setup_xfer(struct i2c_adapter *adap, struct i2c_msg *msg)
 			if (ret)
 				return ret;
 			writel(data, i2c->regs + MXS_I2C_DATA);
+			writel(MXS_I2C_DEBUG0_DMAREQ,
+			       i2c->regs + MXS_I2C_DEBUG0_CLR);
 		}
 	}
 
-	ret = mxs_i2c_pio_wait_cplt(i2c);
+	ret = mxs_i2c_pio_wait_cplt(i2c, 1);
 	if (ret)
 		return ret;