Comments
Patch
@@ -221,6 +221,11 @@ void board_init_r(gd_t *dummy1, ulong dummy2)
#endif
break;
#endif
+#ifdef CONFIG_SPL_USBETH_SUPPORT
+ case BOOT_DEVICE_USBETH:
+ spl_net_load_image("usb_ether");
+ break;
+#endif
default:
debug("SPL: Un-supported Boot Device\n");
hang();
@@ -81,6 +81,8 @@ LIBS-$(CONFIG_SPL_POST_MEM_SUPPORT) += post/drivers/memory.o
LIBS-$(CONFIG_SPL_NET_SUPPORT) += net/libnet.o
LIBS-$(CONFIG_SPL_ETH_SUPPORT) += drivers/net/libnet.o
LIBS-$(CONFIG_SPL_ETH_SUPPORT) += drivers/net/phy/libphy.o
+LIBS-$(CONFIG_SPL_MUSB_NEW_SUPPORT) += drivers/usb/musb-new/libusb_musb-new.o
+LIBS-$(CONFIG_SPL_USBETH_SUPPORT) += drivers/usb/gadget/libusb_gadget.o
ifneq ($(CONFIG_AM33XX)$(CONFIG_OMAP34XX)$(CONFIG_OMAP44XX)$(CONFIG_OMAP54XX),)
LIBS-y += $(CPUDIR)/omap-common/libomap-common.o
In case of usbeth booting just call net_load_image("usb_ether"). This patch also adds CONFIG_SPL_USBETH_SUPPORT and CONFIG_SPL_MUSB_NEW_SUPPORT config options to enable linking of SPL against USB gagdet support and new MUSB driver resp. Signed-off-by: Ilya Yanok <ilya.yanok@cogentembedded.com> --- common/spl/spl.c | 5 +++++ spl/Makefile | 2 ++ 2 files changed, 7 insertions(+)