@@ -2495,9 +2495,11 @@ static struct sk_buff *receive_copy(stru
skb->ip_summed = re->skb->ip_summed;
skb->csum = re->skb->csum;
skb->rxhash = re->skb->rxhash;
+ skb->vlan_tci = re->skb->vlan_tci;
pci_dma_sync_single_for_device(sky2->hw->pdev, re->data_addr,
length, PCI_DMA_FROMDEVICE);
+ re->skb->vlan_tci = 0;
re->skb->rxhash = 0;
re->skb->ip_summed = CHECKSUM_NONE;
skb_put(skb, length);
@@ -2583,9 +2585,6 @@ static struct sk_buff *sky2_receive(stru
struct sk_buff *skb = NULL;
u16 count = (status & GMR_FS_LEN) >> 16;
- if (status & GMR_FS_VLAN)
- count -= VLAN_HLEN; /* Account for vlan tag */
-
netif_printk(sky2, rx_status, KERN_DEBUG, dev,
"rx slot %u status 0x%x len %d\n",
sky2->rx_next, status, length);
@@ -2593,6 +2592,9 @@ static struct sk_buff *sky2_receive(stru
sky2->rx_next = (sky2->rx_next + 1) % sky2->rx_pending;
prefetch(sky2->rx_ring + sky2->rx_next);
+ if (vlan_tx_tag_present(re->skb))
+ count -= VLAN_HLEN; /* Account for vlan tag */
+
/* This chip has hardware problems that generates bogus status.
* So do only marginal checking and expect higher level protocols
* to handle crap frames.
@@ -2650,11 +2652,8 @@ static inline void sky2_tx_done(struct n
}
static inline void sky2_skb_rx(const struct sky2_port *sky2,
- u32 status, struct sk_buff *skb)
+ struct sk_buff *skb)
{
- if (status & GMR_FS_VLAN)
- __vlan_hwaccel_put_tag(skb, be16_to_cpu(sky2->rx_tag));
-
if (skb->ip_summed == CHECKSUM_NONE)
netif_receive_skb(skb);
else
@@ -2708,6 +2707,14 @@ static void sky2_rx_checksum(struct sky2
}
}
+static void sky2_rx_tag(struct sky2_port *sky2, u16 length)
+{
+ struct sk_buff *skb;
+
+ skb = sky2->rx_ring[sky2->rx_next].skb;
+ __vlan_hwaccel_put_tag(skb, be16_to_cpu(length));
+}
+
static void sky2_rx_hash(struct sky2_port *sky2, u32 status)
{
struct sk_buff *skb;
@@ -2766,8 +2773,7 @@ static int sky2_status_intr(struct sky2_
}
skb->protocol = eth_type_trans(skb, dev);
-
- sky2_skb_rx(sky2, status, skb);
+ sky2_skb_rx(sky2, skb);
/* Stop after net poll weight */
if (++work_done >= to_do)
@@ -2775,11 +2781,11 @@ static int sky2_status_intr(struct sky2_
break;
case OP_RXVLAN:
- sky2->rx_tag = length;
+ sky2_rx_tag(sky2, length);
break;
case OP_RXCHKSVLAN:
- sky2->rx_tag = length;
+ sky2_rx_tag(sky2, length);
/* fall through */
case OP_RXCHKS:
if (likely(dev->features & NETIF_F_RXCSUM))
@@ -2241,7 +2241,6 @@ struct sky2_port {
u16 rx_pending;
u16 rx_data_size;
u16 rx_nfrags;
- u16 rx_tag;
struct {
unsigned long last;
Bug: The VLAN bit of the MAC RX Status Word is unreliable in several older supported chips. Sometimes the VLAN bit is not set for valid VLAN packets and also sometimes the VLAN bit is set for non-VLAN packets that came after a VLAN packet. This results in a receive length error when VLAN hardware tagging is enabled. Fix: Variation on original fix proposed by Mirko. The VLAN information is decoded in the status loop, and can be applied to the received SKB there. This eliminates the need for the separate tag field in the interface data structure. The tag has to be copied and cleared if packet is copied. This version checked out with vlan and normal traffic. Note: vlan_tx_tag_present should be renamed vlan_tag_present, but that is outside scope of this. Reported-by: Mirko Lindner <mlindner@marvell.com> Signed-off-by: Stephen Hemminger <shemminger@vyatta.com> -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html