@@ -74,8 +74,6 @@
#define AT_RX_BUF_SIZE (ETH_FRAME_LEN + VLAN_HLEN + ETH_FCS_LEN)
#define MAX_JUMBO_FRAME_SIZE (6*1024)
-#define MAX_TSO_FRAME_SIZE (7*1024)
-#define MAX_TX_OFFLOAD_THRESH (9*1024)
#define AT_MAX_RECEIVE_QUEUE 4
#define AT_DEF_RECEIVE_QUEUE 1
@@ -500,6 +500,7 @@ int atl1c_phy_power_saving(struct atl1c_hw *hw);
/* Jumbo packet Threshold for task offload */
#define REG_TX_TSO_OFFLOAD_THRESH 0x1594 /* In 8-bytes */
#define TX_TSO_OFFLOAD_THRESH_MASK 0x07FF
+#define MAX_TSO_FRAME_SIZE (7*1024)
#define REG_TXF_WATER_MARK 0x1598 /* In 8-bytes */
#define TXF_WATER_MARK_MASK 0x0FFF
@@ -501,11 +501,16 @@ static int atl1c_set_features(struct net_device *netdev,
static int atl1c_change_mtu(struct net_device *netdev, int new_mtu)
{
struct atl1c_adapter *adapter = netdev_priv(netdev);
+ struct atl1c_hw *hw = &adapter->hw;
int old_mtu = netdev->mtu;
int max_frame = new_mtu + ETH_HLEN + ETH_FCS_LEN + VLAN_HLEN;
- if ((max_frame < ETH_ZLEN + ETH_FCS_LEN) ||
- (max_frame > MAX_JUMBO_FRAME_SIZE)) {
+ /* Fast Ethernet controller doesn't support jumbo packet */
+ if (((hw->nic_type == athr_l2c ||
+ hw->nic_type == athr_l2c_b ||
+ hw->nic_type == athr_l2c_b2) && new_mtu > ETH_DATA_LEN) ||
+ max_frame < ETH_ZLEN + ETH_FCS_LEN ||
+ max_frame > MAX_JUMBO_FRAME_SIZE) {
if (netif_msg_link(adapter))
dev_warn(&adapter->pdev->dev, "invalid MTU setting\n");
return -EINVAL;
@@ -1049,7 +1054,7 @@ static void atl1c_configure_tx(struct atl1c_adapter *adapter)
u16 tx_offload_thresh;
u32 txq_ctrl_data;
- tx_offload_thresh = MAX_TX_OFFLOAD_THRESH;
+ tx_offload_thresh = MAX_TSO_FRAME_SIZE;
AT_WRITE_REG(hw, REG_TX_TSO_OFFLOAD_THRESH,
(tx_offload_thresh >> 3) & TX_TSO_OFFLOAD_THRESH_MASK);
max_pay_load = pcie_get_readrq(adapter->pdev) >> 8;
atl1c_configure_tx used a wrong value of MAX_TX_OFFLOAD_THRESH(9KB) for TSO threshold. the right value should be 7KB Fast Ethernet controller doesn't support Jumbo frame. Signed-off-by: xiong <xiong@qca.qualcomm.com> --- drivers/net/ethernet/atheros/atl1c/atl1c.h | 2 -- drivers/net/ethernet/atheros/atl1c/atl1c_hw.h | 1 + drivers/net/ethernet/atheros/atl1c/atl1c_main.c | 11 ++++++++--- 3 files changed, 9 insertions(+), 5 deletions(-)