@@ -1269,18 +1269,16 @@ static void e1000_initialize_hw_bits_82571(struct e1000_hw *hw)
reg |= E1000_PBA_ECC_CORR_EN;
ew32(PBA_ECC, reg);
}
+
/*
* Workaround for hardware errata.
* Ensure that DMA Dynamic Clock gating is disabled on 82571 and 82572
*/
-
- if ((hw->mac.type == e1000_82571) ||
- (hw->mac.type == e1000_82572)) {
- reg = er32(CTRL_EXT);
- reg &= ~E1000_CTRL_EXT_DMA_DYN_CLK_EN;
- ew32(CTRL_EXT, reg);
- }
-
+ if ((hw->mac.type == e1000_82571) || (hw->mac.type == e1000_82572)) {
+ reg = er32(CTRL_EXT);
+ reg &= ~E1000_CTRL_EXT_DMA_DYN_CLK_EN;
+ ew32(CTRL_EXT, reg);
+ }
/* PCI-Ex Control Registers */
switch (hw->mac.type) {
@@ -1230,9 +1230,8 @@ s32 e1000_configure_k1_ich8lan(struct e1000_hw *hw, bool k1_enable)
u32 reg = 0;
u16 kmrn_reg = 0;
- ret_val = e1000e_read_kmrn_reg_locked(hw,
- E1000_KMRNCTRLSTA_K1_CONFIG,
- &kmrn_reg);
+ ret_val = e1000e_read_kmrn_reg_locked(hw, E1000_KMRNCTRLSTA_K1_CONFIG,
+ &kmrn_reg);
if (ret_val)
return ret_val;
@@ -1241,9 +1240,8 @@ s32 e1000_configure_k1_ich8lan(struct e1000_hw *hw, bool k1_enable)
else
kmrn_reg &= ~E1000_KMRNCTRLSTA_K1_ENABLE;
- ret_val = e1000e_write_kmrn_reg_locked(hw,
- E1000_KMRNCTRLSTA_K1_CONFIG,
- kmrn_reg);
+ ret_val = e1000e_write_kmrn_reg_locked(hw, E1000_KMRNCTRLSTA_K1_CONFIG,
+ kmrn_reg);
if (ret_val)
return ret_val;
@@ -629,7 +629,7 @@ s32 e1000e_check_for_serdes_link(struct e1000_hw *hw)
if (E1000_TXCW_ANE & er32(TXCW)) {
status = er32(STATUS);
if (status & E1000_STATUS_LU) {
- /* SYNCH bit and IV bit are sticky, so reread rxcw. */
+ /* SYNCH bit and IV bit are sticky, so reread rxcw. */
udelay(10);
rxcw = er32(RXCW);
if (rxcw & E1000_RXCW_SYNCH) {
@@ -3262,6 +3262,7 @@ static void e1000e_set_rx_mode(struct net_device *netdev)
e1000e_vlan_filter_disable(adapter);
} else {
int count;
+
if (netdev->flags & IFF_ALLMULTI) {
rctl |= E1000_RCTL_MPE;
} else {
@@ -6103,7 +6104,6 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
const struct e1000_info *ei = e1000_info_tbl[ent->driver_data];
resource_size_t mmio_start, mmio_len;
resource_size_t flash_start, flash_len;
-
static int cards_found;
u16 aspm_disable_flag = 0;
int i, err, pci_using_dac;
@@ -6347,11 +6347,11 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
} else if (adapter->flags & FLAG_APME_IN_CTRL3) {
if (adapter->flags & FLAG_APME_CHECK_PORT_B &&
(adapter->hw.bus.func == 1))
- e1000_read_nvm(&adapter->hw,
- NVM_INIT_CONTROL3_PORT_B, 1, &eeprom_data);
+ e1000_read_nvm(&adapter->hw, NVM_INIT_CONTROL3_PORT_B,
+ 1, &eeprom_data);
else
- e1000_read_nvm(&adapter->hw,
- NVM_INIT_CONTROL3_PORT_A, 1, &eeprom_data);
+ e1000_read_nvm(&adapter->hw, NVM_INIT_CONTROL3_PORT_A,
+ 1, &eeprom_data);
}
/* fetch WoL from EEPROM */
@@ -1007,12 +1007,12 @@ static s32 e1000_phy_setup_autoneg(struct e1000_hw *hw)
* The possible values of the "fc" parameter are:
* 0: Flow control is completely disabled
* 1: Rx flow control is enabled (we can receive pause frames
- * but not send pause frames).
+ * but not send pause frames).
* 2: Tx flow control is enabled (we can send pause frames
- * but we do not support receiving pause frames).
+ * but we do not support receiving pause frames).
* 3: Both Rx and Tx flow control (symmetric) are enabled.
* other: No software override. The flow control configuration
- * in the EEPROM is used.
+ * in the EEPROM is used.
*/
switch (hw->fc.current_mode) {
case e1000_fc_none:
@@ -1172,10 +1172,8 @@ s32 e1000e_setup_copper_link(struct e1000_hw *hw)
* Check link status. Wait up to 100 microseconds for link to become
* valid.
*/
- ret_val = e1000e_phy_has_link_generic(hw,
- COPPER_LINK_UP_LIMIT,
- 10,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, COPPER_LINK_UP_LIMIT, 10,
+ &link);
if (ret_val)
return ret_val;
@@ -1237,10 +1235,8 @@ s32 e1000e_phy_force_speed_duplex_igp(struct e1000_hw *hw)
if (phy->autoneg_wait_to_complete) {
e_dbg("Waiting for forced speed/duplex link on IGP phy.\n");
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
if (ret_val)
return ret_val;
@@ -1248,10 +1244,8 @@ s32 e1000e_phy_force_speed_duplex_igp(struct e1000_hw *hw)
e_dbg("Link taking longer than expected.\n");
/* Try once more */
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
}
return ret_val;
@@ -1412,10 +1406,8 @@ s32 e1000_phy_force_speed_duplex_ife(struct e1000_hw *hw)
if (phy->autoneg_wait_to_complete) {
e_dbg("Waiting for forced speed/duplex link on IFE phy.\n");
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
if (ret_val)
return ret_val;
@@ -1423,10 +1415,8 @@ s32 e1000_phy_force_speed_duplex_ife(struct e1000_hw *hw)
e_dbg("Link taking longer than expected.\n");
/* Try once more */
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
if (ret_val)
return ret_val;
}
@@ -2167,6 +2157,7 @@ s32 e1000e_phy_hw_reset_generic(struct e1000_hw *hw)
s32 e1000e_get_cfg_done(struct e1000_hw *hw)
{
mdelay(10);
+
return 0;
}
@@ -3155,13 +3146,11 @@ s32 e1000_link_stall_workaround_hv(struct e1000_hw *hw)
if (ret_val)
return ret_val;
- data &= BM_CS_STATUS_LINK_UP |
- BM_CS_STATUS_RESOLVED |
- BM_CS_STATUS_SPEED_MASK;
+ data &= BM_CS_STATUS_LINK_UP | BM_CS_STATUS_RESOLVED |
+ BM_CS_STATUS_SPEED_MASK;
- if (data != (BM_CS_STATUS_LINK_UP |
- BM_CS_STATUS_RESOLVED |
- BM_CS_STATUS_SPEED_1000))
+ if (data != (BM_CS_STATUS_LINK_UP | BM_CS_STATUS_RESOLVED |
+ BM_CS_STATUS_SPEED_1000))
return 0;
mdelay(200);
@@ -3227,10 +3216,8 @@ s32 e1000_phy_force_speed_duplex_82577(struct e1000_hw *hw)
if (phy->autoneg_wait_to_complete) {
e_dbg("Waiting for forced speed/duplex link on 82577 phy\n");
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
if (ret_val)
return ret_val;
@@ -3238,10 +3225,8 @@ s32 e1000_phy_force_speed_duplex_82577(struct e1000_hw *hw)
e_dbg("Link taking longer than expected.\n");
/* Try once more */
- ret_val = e1000e_phy_has_link_generic(hw,
- PHY_FORCE_LIMIT,
- 100000,
- &link);
+ ret_val = e1000e_phy_has_link_generic(hw, PHY_FORCE_LIMIT,
+ 100000, &link);
}
return ret_val;