| Message ID | 1330636394-25173-1-git-send-email-troy.kisky@boundarydevices.com |
|---|---|
| State | Rejected |
| Delegated to: | Stefano Babic |
| Headers | show |
On 01/03/2012 22:13, Troy Kisky wrote: > mach-type update will rename MACH_TYPE_SHEEVAD to > MACH_TYPE_GPLUGD > > Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com> > --- > board/Marvell/gplugd/gplugd.c | 2 +- > 1 files changed, 1 insertions(+), 1 deletions(-) > > diff --git a/board/Marvell/gplugd/gplugd.c b/board/Marvell/gplugd/gplugd.c > index a697c19..8d9916a 100644 > --- a/board/Marvell/gplugd/gplugd.c > +++ b/board/Marvell/gplugd/gplugd.c > @@ -92,7 +92,7 @@ int board_init(void) > (struct armd1apb2_registers *)ARMD1_APBC2_BASE; > > /* arch number of Board */ > - gd->bd->bi_arch_number = MACH_TYPE_SHEEVAD; > + gd->bd->bi_arch_number = CONFIG_MACH_TYPE; You do not need it to add this line. This is already done in common code when CONFIG_MACH_TYPE is set. Best regards, Stefano Babic
diff --git a/board/Marvell/gplugd/gplugd.c b/board/Marvell/gplugd/gplugd.c index a697c19..8d9916a 100644 --- a/board/Marvell/gplugd/gplugd.c +++ b/board/Marvell/gplugd/gplugd.c @@ -92,7 +92,7 @@ int board_init(void) (struct armd1apb2_registers *)ARMD1_APBC2_BASE; /* arch number of Board */ - gd->bd->bi_arch_number = MACH_TYPE_SHEEVAD; + gd->bd->bi_arch_number = CONFIG_MACH_TYPE; /* adress of boot parameters */ gd->bd->bi_boot_params = armd1_sdram_base(0) + 0x100; /* Assert PHY_RST# */
mach-type update will rename MACH_TYPE_SHEEVAD to MACH_TYPE_GPLUGD Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com> --- board/Marvell/gplugd/gplugd.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-)