@@ -101,6 +101,14 @@ X!Enet/core/wireless.c
<sect1><title>Synchronous PPP</title>
!Edrivers/net/wan/syncppp.c
</sect1>
+ <sect1><title>WiMAX</title>
+!Enet/wimax/op-msg.c
+!Enet/wimax/op-reset.c
+!Enet/wimax/op-rfkill.c
+!Enet/wimax/stack.c
+!Iinclude/net/wimax.h
+!Iinclude/linux/wimax.h
+ </sect1>
</chapter>
</book>
@@ -251,6 +251,8 @@ source "net/ieee80211/Kconfig"
endif # WIRELESS
+source "net/wimax/Kconfig"
+
source "net/rfkill/Kconfig"
source "net/9p/Kconfig"
@@ -61,3 +61,4 @@ obj-$(CONFIG_NET_9P) += 9p/
ifeq ($(CONFIG_NET),y)
obj-$(CONFIG_SYSCTL) += sysctl_net.o
endif
+obj-$(CONFIG_WIMAX) += wimax/
new file mode 100644
@@ -0,0 +1,36 @@
+#
+# WiMAX LAN device configuration
+#
+
+menuconfig WIMAX
+ tristate "WiMAX Wireless Broadband support"
+ help
+
+ Select to configure support for devices that provide wireless
+ broadband connectivity using the WiMAX protocol (IEEE 802.16).
+
+ Please note that most of these devices require signing up for
+ a service plan with a provider.
+
+ The different WiMAX drivers can be enabled in the menu entry
+
+ Device Drivers > Network device support > WiMAX Wireless Broadband devices
+
+ If unsure, it is safe to select M (module).
+
+config WIMAX_DEBUG_LEVEL
+ int "WiMAX debug level"
+ depends on WIMAX
+ default 8
+ help
+
+ Select the maximum debug verbosity level to be compiled into
+ the WiMAX stack code.
+
+ By default, debug messages are disabled at runtime and can be
+ selectively enabled for different parts of the code using the
+ sysfs debug-levels file.
+
+ If set at zero, this will compile out all the debug code.
+
+ It is recommended that it is left at 8.
new file mode 100644
@@ -0,0 +1,13 @@
+
+obj-$(CONFIG_WIMAX) += wimax.o
+
+wimax-objs := \
+ id-table.o \
+ op-msg.o \
+ op-reset.o \
+ op-rfkill.o \
+ stack.o
+
+wimax-$(CONFIG_DEBUG_FS) += debugfs.o
+
+
This patch provides Makefile and KConfig for the WiMAX stack, integrating them into the networking stack's Makefile, Kconfig and doc-book templates. Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com> --- Documentation/DocBook/networking.tmpl | 8 +++++++ net/Kconfig | 2 + net/Makefile | 1 + net/wimax/Kconfig | 36 +++++++++++++++++++++++++++++++++ net/wimax/Makefile | 13 +++++++++++ 5 files changed, 60 insertions(+), 0 deletions(-) create mode 100644 net/wimax/Kconfig create mode 100644 net/wimax/Makefile