@@ -44,7 +44,7 @@ typedef struct V9fsThPool {
qemu_coroutine_self()); \
qemu_bh_schedule(co_bh); \
/* \
- * yeild in qemu thread and re-enter back \
+ * yield in qemu thread and re-enter back \
* in glib worker thread \
*/ \
qemu_coroutine_yield(); \
@@ -520,7 +520,7 @@ static int handle_name_to_path(FsContext *ctx, V9fsPath *dir_path,
}
fh = g_malloc(sizeof(struct file_handle) + data->handle_bytes);
fh->handle_bytes = data->handle_bytes;
- /* add a "./" at the begining of the path */
+ /* add a "./" at the beginning of the path */
snprintf(buffer, PATH_MAX, "./%s", name);
/* flag = 0 imply don't follow symlink */
ret = name_to_handle(dirfd, buffer, fh, &mnt_id, 0);
@@ -2,7 +2,7 @@
* QEMU Alpha DP264/CLIPPER hardware system emulator.
*
* Choose CLIPPER IRQ mappings over, say, DP264, MONET, or WEBBRICK
- * variants because CLIPPER doesn't have an SMC669 SuperIO controler
+ * variants because CLIPPER doesn't have an SMC669 SuperIO controller
* that we need to emulate as well.
*/
@@ -602,7 +602,7 @@ static uint32_t gic_cpu_read(gic_state *s, int cpu, int offset)
return 0;
case 0x0c: /* Acknowledge */
return gic_acknowledge_irq(s, cpu);
- case 0x14: /* Runing Priority */
+ case 0x14: /* Running Priority */
return s->running_priority[cpu];
case 0x18: /* Highest Pending Interrupt */
return s->current_pending[cpu];
@@ -222,7 +222,7 @@ static void csrhci_in_packet(struct csrhci_s *s, uint8_t *pkt)
rpkt = csrhci_out_packet_csr(s, H4_NEG_PKT, 10);
- *rpkt ++ = 0x20; /* Operational settings negotation Ok */
+ *rpkt ++ = 0x20; /* Operational settings negotiation Ok */
memcpy(rpkt, pkt, 7); rpkt += 7;
*rpkt ++ = 0xff;
*rpkt = 0xff;
@@ -295,7 +295,7 @@
#define E1000_KUMCTRLSTA 0x00034 /* MAC-PHY interface - RW */
#define E1000_MDPHYA 0x0003C /* PHY address - RW */
-#define E1000_MANC2H 0x05860 /* Managment Control To Host - RW */
+#define E1000_MANC2H 0x05860 /* Management Control To Host - RW */
#define E1000_SW_FW_SYNC 0x05B5C /* Software-Firmware Synchronization - RW */
#define E1000_GCR 0x05B00 /* PCI-Ex Control */
@@ -180,7 +180,7 @@ struct fs_dma_channel
struct dma_descr_context current_c;
struct dma_descr_data current_d;
- /* Controll registers. */
+ /* Control registers. */
uint32_t regs[DMA_REG_MAX];
};
@@ -53,7 +53,7 @@ static void pic_update(struct etrax_pic *fs)
fs->regs[R_R_MASKED_VECT] = fs->regs[R_R_VECT] & fs->regs[R_RW_MASK];
- /* The ETRAX interrupt controller signals interrupts to teh core
+ /* The ETRAX interrupt controller signals interrupts to the core
through an interrupt request wire and an irq vector bus. If
multiple interrupts are simultaneously active it chooses vector
0x30 and lets the sw choose the priorities. */
@@ -715,7 +715,7 @@ static void OPLCloseTable( void )
free(VIB_TABLE);
}
-/* CSM Key Controll */
+/* CSM Key Control */
INLINE void CSMKeyControll(OPL_CH *CH)
{
OPL_SLOT *slot1 = &CH->SLOT[SLOT1];
@@ -762,7 +762,7 @@ static void OPLWriteReg(FM_OPL *OPL, int r, int v)
switch(r&0xe0)
{
- case 0x00: /* 00-1f:controll */
+ case 0x00: /* 00-1f:control */
switch(r&0x1f)
{
case 0x01:
@@ -826,7 +826,7 @@ static void OPLWriteReg(FM_OPL *OPL, int r, int v)
LOG(LOG_WAR,("OPL:write unmapped KEYBOARD port\n"));
}
return;
- case 0x07: /* DELTA-T controll : START,REC,MEMDATA,REPT,SPOFF,x,x,RST */
+ case 0x07: /* DELTA-T control : START,REC,MEMDATA,REPT,SPOFF,x,x,RST */
if(OPL->type&OPL_TYPE_ADPCM)
YM_DELTAT_ADPCM_Write(OPL->deltat,r-0x07,v);
return;
@@ -1380,7 +1380,7 @@ int OPLTimerOver(FM_OPL *OPL,int c)
else
{ /* Timer A */
OPL_STATUS_SET(OPL,0x40);
- /* CSM mode key,TL controll */
+ /* CSM mode key,TL control */
if( OPL->mode & 0x80 )
{ /* CSM mode total level latch and auto key on */
int ch;
@@ -27,7 +27,7 @@
/* data types (need to be adjusted if neither a VC6 nor a C99 compatible compiler is used) */
-#if defined _WIN32 && defined _MSC_VER /* doesnt support other win32 compilers yet, do it yourself... */
+#if defined _WIN32 && defined _MSC_VER /* doesn't support other win32 compilers yet, do it yourself... */
typedef unsigned char GUSbyte;
typedef unsigned short GUSword;
typedef unsigned int GUSdword;
@@ -517,7 +517,7 @@ void gus_dma_transferdata(GUSEmuState * state, char *dma_addr, unsigned int coun
int offset = (GUSregw(GUS42DMAStart) << 4) + (GUSregb(GUS50DMAHigh) & 0xf);
if (state->gusdma >= 4)
offset = (offset & 0xc0000) + (2 * (offset & 0x1fff0)); /* 16 bit address translation */
- destaddr = (char *) state->himemaddr + offset; /* wavetable RAM adress */
+ destaddr = (char *) state->himemaddr + offset; /* wavetable RAM address */
}
GUSregw(GUS42DMAStart) += (GUSword) (count >> 4); /* ToDo: add 16bit GUS page limit? */
@@ -1000,7 +1000,7 @@ void ide_exec_cmd(IDEBus *bus, uint32_t val)
printf("ide: CMD=%02x\n", val);
#endif
s = idebus_active_if(bus);
- /* ignore commands to non existant slave */
+ /* ignore commands to non existent slave */
if (s != bus->ifs && !s->bs)
return;
@@ -697,7 +697,7 @@ static uint32_t do_phy_read(lan9118_state *s, int reg)
return 0x0007;
case 3: /* ID2 */
return 0xc0d1;
- case 4: /* Auto-neg advertisment */
+ case 4: /* Auto-neg advertisement */
return s->phy_advertise;
case 5: /* Auto-neg Link Partner Ability */
return 0x0f71;
@@ -731,7 +731,7 @@ static void do_phy_write(lan9118_state *s, int reg, uint32_t val)
s->phy_status |= 0x0020;
}
break;
- case 4: /* Auto-neg advertisment */
+ case 4: /* Auto-neg advertisement */
s->phy_advertise = (val & 0x2d7f) | 0x80;
break;
/* TODO 17, 18, 27, 31 */
@@ -826,7 +826,7 @@ typedef struct PCIEAERErrorName {
} PCIEAERErrorName;
/*
- * AER error name -> value convertion table
+ * AER error name -> value conversion table
* This naming scheme is same to linux aer-injection tool.
*/
static const struct PCIEAERErrorName pcie_aer_error_list[] = {
@@ -358,7 +358,7 @@ static void pl110_write(void *opaque, target_phys_addr_t offset,
int n;
/* For simplicity invalidate the display whenever a control register
- is writen to. */
+ is written to. */
s->invalidate = 1;
if (offset >= 0x200 && offset < 0x400) {
/* Pallette. */
@@ -2662,7 +2662,7 @@ static void rtl8139_IntrStatus_write(RTL8139State *s, uint32_t val)
* Computing if we miss an interrupt here is not that correct but
* considered that we should have had already an interrupt
* and probably emulated is slower is better to assume this resetting was
- * done before testing on previous rtl8139_update_irq lead to IRQ loosing
+ * done before testing on previous rtl8139_update_irq lead to IRQ losing
*/
rtl8139_set_next_tctr_time(s, qemu_get_clock_ns(vm_clock));
rtl8139_update_irq(s);
@@ -157,7 +157,7 @@
* Exeption-related registers
*/
-/* Immediate data for TRAPA instuction - TRA */
+/* Immediate data for TRAPA instruction - TRA */
#define SH7750_TRA_REGOFS 0x000020 /* offset */
#define SH7750_TRA SH7750_P4_REG32(SH7750_TRA_REGOFS)
#define SH7750_TRA_A7 SH7750_A7_REG32(SH7750_TRA_REGOFS)
@@ -141,7 +141,7 @@ typedef struct sPAPREnvironment {
#define H_DABRX_KERNEL (1ULL<<(63-62))
#define H_DABRX_USER (1ULL<<(63-63))
-/* Each control block has to be on a 4K bondary */
+/* Each control block has to be on a 4K boundary */
#define H_CB_ALIGNMENT 4096
/* pSeries hypervisor opcodes */
@@ -123,7 +123,7 @@ static int ssd0303_send(i2c_slave *i2c, uint8_t data)
case 0xa7: /* Inverse on. */
s->inverse = 1;
break;
- case 0xa8: /* Set multipled ratio (Ignored). */
+ case 0xa8: /* Set multiplied ratio (Ignored). */
s->cmd_state = SSD0303_CMD_SKIP1;
break;
case 0xad: /* DC-DC power control. */
@@ -42,7 +42,7 @@ typedef struct IB700state {
/* This is the timer. We use a global here because the watchdog
* code ensures there is only one watchdog (it is located at a fixed,
- * unchangable IO port, so there could only ever be one anyway).
+ * unchangeable IO port, so there could only ever be one anyway).
*/
/* A write to this register enables the timer. */
adress->address advertisment->advertisement begining->beginning bondary->boundary controler->controller controll->control convertion->conversion doesnt->doesn't existant->existent instuction->instruction loosing->losing managment->management multipled->multiplied negotation->negotiation runing->running teh->the unchangable->unchangeable writen->written yeild->yield Signed-off-by: Stefan Weil <sw@weilnetz.de> --- hw/9pfs/virtio-9p-coth.h | 2 +- hw/9pfs/virtio-9p-handle.c | 2 +- hw/alpha_dp264.c | 2 +- hw/arm_gic.c | 2 +- hw/bt-hci-csr.c | 2 +- hw/e1000_hw.h | 2 +- hw/etraxfs_dma.c | 2 +- hw/etraxfs_pic.c | 2 +- hw/fmopl.c | 8 ++++---- hw/gusemu.h | 2 +- hw/gusemu_hal.c | 2 +- hw/ide/core.c | 2 +- hw/lan9118.c | 4 ++-- hw/pcie_aer.c | 2 +- hw/pl110.c | 2 +- hw/rtl8139.c | 2 +- hw/sh7750_regs.h | 2 +- hw/spapr.h | 2 +- hw/ssd0303.c | 2 +- hw/wdt_ib700.c | 2 +- 20 files changed, 24 insertions(+), 24 deletions(-)