[v3,1/2] dt-bindings: serial: document fsl,inverted-tx and -rx options
diff mbox series

Message ID 20200212163538.3006-2-ghilliard@kopismobile.com
State Not Applicable
Headers show
Series
  • Implement support for inverted serial TX/RX on i.MX
Related show

Checks

Context Check Description
robh/checkpatch success

Commit Message

George Hilliard Feb. 12, 2020, 4:35 p.m. UTC
Add a description for the new fsl,inverted-tx and fsl,inverted-rx
options for the i.MX UART peripheral.

Signed-off-by: George Hilliard <ghilliard@kopismobile.com>
---
v1..v2: Removed confidentiality spam

 Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 4 ++++
 1 file changed, 4 insertions(+)

Comments

Rob Herring Feb. 18, 2020, 11:07 p.m. UTC | #1
On Wed, 12 Feb 2020 10:35:37 -0600, George Hilliard wrote:
> Add a description for the new fsl,inverted-tx and fsl,inverted-rx
> options for the i.MX UART peripheral.
> 
> Signed-off-by: George Hilliard <ghilliard@kopismobile.com>
> ---
> v1..v2: Removed confidentiality spam
> 
>  Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 4 ++++
>  1 file changed, 4 insertions(+)
> 

Reviewed-by: Rob Herring <robh@kernel.org>

Patch
diff mbox series

diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
index 35957cbf1571..c8d677f9491f 100644
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
@@ -8,6 +8,10 @@  Required properties:
 Optional properties:
 - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
                   in DCE mode by default.
+- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached
+  to the peripheral inverts the signal transmitted or received,
+  respectively, and that the peripheral should invert its output/input
+  using the INVT/INVR registers.
 - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
   linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485
   you must enable either the "uart-has-rtscts" or the "rts-gpios"