diff mbox

[U-Boot,11/14] omap_gpmc: use SOFTECC in SPL if it's enabled

Message ID 1320189368-9763-12-git-send-email-yanok@emcraft.com
State Superseded
Delegated to: Scott Wood
Headers show

Commit Message

Ilya Yanok Nov. 1, 2011, 11:16 p.m. UTC 
Use software ECC for the SPL build if support for software ECC in SPL is
enabled.

Signed-off-by: Ilya Yanok <yanok@emcraft.com>
---
 drivers/mtd/nand/omap_gpmc.c |    4 +++-
 1 files changed, 3 insertions(+), 1 deletions(-)
diff mbox

Patch

diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c
index 5bbec48..1dfe074 100644
--- a/drivers/mtd/nand/omap_gpmc.c
+++ b/drivers/mtd/nand/omap_gpmc.c
@@ -348,7 +348,7 @@  int board_nand_init(struct nand_chip *nand)
 
 	nand->chip_delay = 100;
 	/* Default ECC mode */
-#ifndef CONFIG_SPL_BUILD
+#if !defined(CONFIG_SPL_BUILD) || defined(CONFIG_SPL_NAND_SOFTECC)
 	nand->ecc.mode = NAND_ECC_SOFT;
 #else
 	nand->ecc.mode = NAND_ECC_HW;
@@ -359,7 +359,9 @@  int board_nand_init(struct nand_chip *nand)
 	nand->ecc.correct = omap_correct_data;
 	nand->ecc.calculate = omap_calculate_ecc;
 	omap_hwecc_init(nand);
+#endif
 
+#ifdef CONFIG_SPL_BUILD
 	if (nand->options & NAND_BUSWIDTH_16)
 		nand->read_buf = nand_read_buf16;
 	else