Message ID | 1318519157-4945-1-git-send-email-agust@denx.de |
---|---|
State | Accepted |
Commit | 4fc823ddb43ab26a393da49f356fcad208e7064f |
Headers | show |
Hi Anatolij, > A delay of approximately 250 ms after PCI bus reset in > pci_mpc5xxx_init() is needed to recognize the Coral-PA > controller on the graphic extention board. > > Signed-off-by: Anatolij Gustschin <agust@denx.de> > --- > To make it actually work another patch > "pci: move pcidelay code to new location just before PCI bus scan" > is also required. It has been submitted earlier [1] and there is > already some positive feedback. > > [1] http://patchwork.ozlabs.org/patch/119171/ Acked-by: Detlev Zundel <dzu@denx.de>
Dear Anatolij Gustschin, In message <1318519157-4945-1-git-send-email-agust@denx.de> you wrote: > A delay of approximately 250 ms after PCI bus reset in > pci_mpc5xxx_init() is needed to recognize the Coral-PA > controller on the graphic extention board. > > Signed-off-by: Anatolij Gustschin <agust@denx.de> > --- > To make it actually work another patch > "pci: move pcidelay code to new location just before PCI bus scan" > is also required. It has been submitted earlier [1] and there is > already some positive feedback. > > [1] http://patchwork.ozlabs.org/patch/119171/ > > include/configs/digsy_mtc.h | 1 + > 1 files changed, 1 insertions(+), 0 deletions(-) Applied, thanks. Best regards, Wolfgang Denk
diff --git a/include/configs/digsy_mtc.h b/include/configs/digsy_mtc.h index 522ec57..d0d1eda 100644 --- a/include/configs/digsy_mtc.h +++ b/include/configs/digsy_mtc.h @@ -70,6 +70,7 @@ #define CONFIG_PCI 1 #define CONFIG_PCI_PNP 1 #define CONFIG_PCI_SCAN_SHOW 1 +#define CONFIG_PCI_BOOTDELAY 250 #define CONFIG_PCI_MEM_BUS 0x40000000 #define CONFIG_PCI_MEM_PHYS CONFIG_PCI_MEM_BUS
A delay of approximately 250 ms after PCI bus reset in pci_mpc5xxx_init() is needed to recognize the Coral-PA controller on the graphic extention board. Signed-off-by: Anatolij Gustschin <agust@denx.de> --- To make it actually work another patch "pci: move pcidelay code to new location just before PCI bus scan" is also required. It has been submitted earlier [1] and there is already some positive feedback. [1] http://patchwork.ozlabs.org/patch/119171/ include/configs/digsy_mtc.h | 1 + 1 files changed, 1 insertions(+), 0 deletions(-)