@@ -27,12 +27,47 @@ static inline void ls1012ardb_reset_phy(void)
{
#ifdef CONFIG_TARGET_LS1012ARDB
/* Through reset IO expander reset both RGMII and SGMII PHYs */
+#ifdef CONFIG_DM_I2C
+ struct udevice *dev;
+ int ret;
+
+ /*
+ * The I2C IO-expander PCAL9555A is mouted on I2C1 bus(bus number is 0).
+ */
+ ret = i2c_get_chip_for_busnum(0, I2C_MUX_IO2_ADDR,
+ 1, &dev);
+ if (ret) {
+ printf("%s: Cannot find udev for a bus %d\n", __func__,
+ 0);
+ return;
+ }
+ /* Config port 0
+ * - config pin IOXP_RST_ETH1_B and IOXP_RST_ETH2_B
+ * are enabled as an output.
+ */
+ dm_i2c_reg_write(dev, 6, __PHY_MASK);
+
+ /*
+ * Set port 0 output a value to reset ETH2 interface
+ * - pin IOXP_RST_ETH2_B output 0b0
+ */
+ dm_i2c_reg_write(dev, 2, __PHY_ETH2_MASK);
+ mdelay(10);
+ dm_i2c_reg_write(dev, 2, __PHY_ETH1_MASK);
+ /*
+ * Set port 0 output a value to reset ETH1 interface
+ * - pin IOXP_RST_ETH1_B output 0b0
+ */
+ mdelay(10);
+ dm_i2c_reg_write(dev, 2, 0xFF);
+#else
i2c_reg_write(I2C_MUX_IO2_ADDR, 6, __PHY_MASK);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, __PHY_ETH2_MASK);
mdelay(10);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, __PHY_ETH1_MASK);
mdelay(10);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, 0xFF);
+#endif
mdelay(50);
#endif
}
This supports dm_i2c_* API for board LS1012ARDB Signed-off-by: Biwen Li <biwen.li@nxp.com> --- board/freescale/ls1012ardb/eth.c | 35 ++++++++++++++++++++++++++++++++ 1 file changed, 35 insertions(+)