@@ -171,7 +171,6 @@ int board_early_init_f(void)
{
setup_iomux_uart();
setup_iomux_fec();
- setup_iomux_lcd();
ppd_gpio_init();
return 0;
@@ -25,69 +25,6 @@ static int detect_lcd(struct display_info_t const *dev)
return 1;
}
-struct display_info_t const displays[] = {
- {
- .bus = -1,
- .addr = -1,
- .pixfmt = IPU_PIX_FMT_RGB24,
- .detect = detect_lcd,
- .enable = NULL,
- .mode = {
- .name = "NV-SPWGRGB888",
- .refresh = 60,
- .xres = 800,
- .yres = 480,
- .pixclock = 15384,
- .left_margin = 16,
- .right_margin = 210,
- .upper_margin = 10,
- .lower_margin = 22,
- .hsync_len = 30,
- .vsync_len = 13,
- .sync = FB_SYNC_EXT,
- .vmode = FB_VMODE_NONINTERLACED
- }
- }
-};
-
-size_t display_count = ARRAY_SIZE(displays);
-
-void setup_iomux_lcd(void)
-{
- static const iomux_v3_cfg_t lcd_pads[] = {
- MX53_PAD_DI0_DISP_CLK__IPU_DI0_DISP_CLK,
- MX53_PAD_DI0_PIN15__IPU_DI0_PIN15,
- MX53_PAD_DI0_PIN2__IPU_DI0_PIN2,
- MX53_PAD_DI0_PIN3__IPU_DI0_PIN3,
- MX53_PAD_DISP0_DAT0__IPU_DISP0_DAT_0,
- MX53_PAD_DISP0_DAT1__IPU_DISP0_DAT_1,
- MX53_PAD_DISP0_DAT2__IPU_DISP0_DAT_2,
- MX53_PAD_DISP0_DAT3__IPU_DISP0_DAT_3,
- MX53_PAD_DISP0_DAT4__IPU_DISP0_DAT_4,
- MX53_PAD_DISP0_DAT5__IPU_DISP0_DAT_5,
- MX53_PAD_DISP0_DAT6__IPU_DISP0_DAT_6,
- MX53_PAD_DISP0_DAT7__IPU_DISP0_DAT_7,
- MX53_PAD_DISP0_DAT8__IPU_DISP0_DAT_8,
- MX53_PAD_DISP0_DAT9__IPU_DISP0_DAT_9,
- MX53_PAD_DISP0_DAT10__IPU_DISP0_DAT_10,
- MX53_PAD_DISP0_DAT11__IPU_DISP0_DAT_11,
- MX53_PAD_DISP0_DAT12__IPU_DISP0_DAT_12,
- MX53_PAD_DISP0_DAT13__IPU_DISP0_DAT_13,
- MX53_PAD_DISP0_DAT14__IPU_DISP0_DAT_14,
- MX53_PAD_DISP0_DAT15__IPU_DISP0_DAT_15,
- MX53_PAD_DISP0_DAT16__IPU_DISP0_DAT_16,
- MX53_PAD_DISP0_DAT17__IPU_DISP0_DAT_17,
- MX53_PAD_DISP0_DAT18__IPU_DISP0_DAT_18,
- MX53_PAD_DISP0_DAT19__IPU_DISP0_DAT_19,
- MX53_PAD_DISP0_DAT20__IPU_DISP0_DAT_20,
- MX53_PAD_DISP0_DAT21__IPU_DISP0_DAT_21,
- MX53_PAD_DISP0_DAT22__IPU_DISP0_DAT_22,
- MX53_PAD_DISP0_DAT23__IPU_DISP0_DAT_23,
- };
-
- imx_iomux_v3_setup_multiple_pads(lcd_pads, ARRAY_SIZE(lcd_pads));
-}
-
static void lcd_enable(void)
{
struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
@@ -112,34 +49,47 @@ static void lcd_enable(void)
&iomux->gpr[2]);
}
-static int do_lcd_enable(cmd_tbl_t *cmdtp, int flag, int argc,
- char * const argv[])
+static void do_enable_backlight(struct display_info_t const *dev)
{
- lcd_enable();
-
- int ret;
struct udevice *panel;
- struct udevice *dev;
+ int ret;
+
+ lcd_enable();
ret = uclass_get_device(UCLASS_PANEL, 0, &panel);
- if (ret)
- return ret;
+ if (ret) {
+ printf("Could not find panel: %d\n", ret);
+ return;
+ }
panel_set_backlight(panel, 100);
panel_enable_backlight(panel);
+}
- /* Probe, to find a video device to be used to show a message on
- * the vidconsole.
- */
- ret = uclass_get_device(UCLASS_VIDEO, 0, &dev);
- if (ret)
- return ret;
+struct display_info_t const displays[] = {
+ {
+ .bus = -1,
+ .addr = -1,
+ .pixfmt = IPU_PIX_FMT_RGB24,
+ .detect = detect_lcd,
+ .enable = do_enable_backlight,
+ .mode = {
+ .name = "NV-SPWGRGB888",
+ .refresh = 60,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = 15384,
+ .left_margin = 16,
+ .right_margin = 210,
+ .upper_margin = 10,
+ .lower_margin = 22,
+ .hsync_len = 30,
+ .vsync_len = 13,
+ .sync = FB_SYNC_EXT,
+ .vmode = FB_VMODE_NONINTERLACED
+ }
+ }
+};
- return 0;
-}
+size_t display_count = ARRAY_SIZE(displays);
-U_BOOT_CMD(
- ppd_lcd_enable, 1, 1, do_lcd_enable,
- "enable PPD LCD",
- "no parameters"
-);
@@ -22,6 +22,7 @@ CONFIG_CMD_DHCP=y
CONFIG_CMD_BOOTCOUNT=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
+CONFIG_CMD_CLS=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
@@ -91,7 +91,7 @@
"/boot/bootcause/firstboot\0" \
"swappartitions=setexpr partnum 3 - ${partnum}\0" \
"failbootcmd=" \
- "ppd_lcd_enable; " \
+ "cls; " \
"setcurs 5 4; " \
"lcdputs \"Monitor failed to start. " \
"Try again, or contact GE Service for support.\"; " \
Remove old (incorrect) setup_iomux_lcd. Enable backlight via display enable handler. Use cls command to initiate display in HW agnostic manner. Signed-off-by: Robert Beckett <bob.beckett@collabora.com> --- board/ge/mx53ppd/mx53ppd.c | 1 - board/ge/mx53ppd/mx53ppd_video.c | 118 +++++++++---------------------- configs/mx53ppd_defconfig | 1 + include/configs/mx53ppd.h | 2 +- 4 files changed, 36 insertions(+), 86 deletions(-)