@@ -129,7 +129,7 @@ int sja1105_static_config_reload(struct sja1105_private *priv);
/* From sja1105_spi.c */
int sja1105_xfer_buf(const struct sja1105_private *priv,
sja1105_spi_rw_mode_t rw, u64 reg_addr,
- void *packed_buf, size_t size_bytes);
+ u8 *buf, size_t len);
int sja1105_xfer_u32(const struct sja1105_private *priv,
sja1105_spi_rw_mode_t rw, u64 reg_addr, u32 *value);
int sja1105_xfer_u64(const struct sja1105_private *priv,
@@ -10,8 +10,12 @@
#define SJA1105_SIZE_RESET_CMD 4
#define SJA1105_SIZE_SPI_MSG_HEADER 4
#define SJA1105_SIZE_SPI_MSG_MAXLEN (64 * 4)
-#define SJA1105_SIZE_SPI_TRANSFER_MAX \
- (SJA1105_SIZE_SPI_MSG_HEADER + SJA1105_SIZE_SPI_MSG_MAXLEN)
+
+struct sja1105_chunk {
+ u8 *buf;
+ size_t len;
+ u64 reg_addr;
+};
static void
sja1105_spi_message_pack(void *buf, const struct sja1105_spi_message *msg)
@@ -25,61 +29,98 @@ sja1105_spi_message_pack(void *buf, const struct sja1105_spi_message *msg)
sja1105_pack(buf, &msg->address, 24, 4, size);
}
+#define sja1105_hdr_xfer(xfers, chunk) \
+ ((xfers) + 2 * (chunk))
+#define sja1105_chunk_xfer(xfers, chunk) \
+ ((xfers) + 2 * (chunk) + 1)
+#define sja1105_hdr_buf(hdr_bufs, chunk) \
+ ((hdr_bufs) + (chunk) * SJA1105_SIZE_SPI_MSG_HEADER)
+
/* If @rw is:
* - SPI_WRITE: creates and sends an SPI write message at absolute
- * address reg_addr, taking size_bytes from *packed_buf
+ * address reg_addr, taking @len bytes from *buf
* - SPI_READ: creates and sends an SPI read message from absolute
- * address reg_addr, writing size_bytes into *packed_buf
- *
- * This function should only be called if it is priorly known that
- * @size_bytes is smaller than SIZE_SPI_MSG_MAXLEN. Larger packed buffers
- * are chunked in smaller pieces by sja1105_xfer_long_buf below.
+ * address reg_addr, writing @len bytes into *buf
*/
int sja1105_xfer_buf(const struct sja1105_private *priv,
sja1105_spi_rw_mode_t rw, u64 reg_addr,
- void *packed_buf, size_t size_bytes)
+ u8 *buf, size_t len)
{
- const int msg_len = size_bytes + SJA1105_SIZE_SPI_MSG_HEADER;
- u8 tx_buf[SJA1105_SIZE_SPI_TRANSFER_MAX] = {0};
- u8 rx_buf[SJA1105_SIZE_SPI_TRANSFER_MAX] = {0};
- struct spi_device *spi = priv->spidev;
- struct sja1105_spi_message msg = {0};
- struct spi_transfer xfer = {
- .tx_buf = tx_buf,
- .rx_buf = rx_buf,
- .len = msg_len,
+ struct sja1105_chunk chunk = {
+ .len = min_t(size_t, len, SJA1105_SIZE_SPI_MSG_MAXLEN),
+ .reg_addr = reg_addr,
+ .buf = buf,
};
- struct spi_message m;
- int rc;
-
- if (msg_len > SJA1105_SIZE_SPI_TRANSFER_MAX)
- return -ERANGE;
+ struct spi_device *spi = priv->spidev;
+ struct spi_transfer *xfers;
+ int num_chunks;
+ int rc, i = 0;
+ u8 *hdr_bufs;
- msg.access = rw;
- msg.address = reg_addr;
- if (rw == SPI_READ)
- msg.read_count = size_bytes / 4;
+ num_chunks = DIV_ROUND_UP(len, SJA1105_SIZE_SPI_MSG_MAXLEN);
- sja1105_spi_message_pack(tx_buf, &msg);
+ /* One transfer for each message header, one for each message
+ * payload (chunk).
+ */
+ xfers = kcalloc(2 * num_chunks, sizeof(struct spi_transfer),
+ GFP_KERNEL);
+ if (!xfers)
+ return -ENOMEM;
- if (rw == SPI_WRITE)
- memcpy(tx_buf + SJA1105_SIZE_SPI_MSG_HEADER,
- packed_buf, size_bytes);
+ /* Packed buffers for the num_chunks SPI message headers,
+ * stored as a contiguous array
+ */
+ hdr_bufs = kcalloc(num_chunks, SJA1105_SIZE_SPI_MSG_HEADER,
+ GFP_KERNEL);
+ if (!hdr_bufs) {
+ kfree(xfers);
+ return -ENOMEM;
+ }
- spi_message_init(&m);
- spi_message_add_tail(&xfer, &m);
+ for (i = 0; i < num_chunks; i++) {
+ struct spi_transfer *chunk_xfer = sja1105_chunk_xfer(xfers, i);
+ struct spi_transfer *hdr_xfer = sja1105_hdr_xfer(xfers, i);
+ u8 *hdr_buf = sja1105_hdr_buf(hdr_bufs, i);
+ struct sja1105_spi_message msg;
+
+ /* Populate the transfer's header buffer */
+ msg.address = chunk.reg_addr;
+ msg.access = rw;
+ if (rw == SPI_READ)
+ msg.read_count = chunk.len / 4;
+ else
+ /* Ignored */
+ msg.read_count = 0;
+ sja1105_spi_message_pack(hdr_buf, &msg);
+ hdr_xfer->tx_buf = hdr_buf;
+ hdr_xfer->len = SJA1105_SIZE_SPI_MSG_HEADER;
+
+ /* Populate the transfer's data buffer */
+ if (rw == SPI_READ)
+ chunk_xfer->rx_buf = chunk.buf;
+ else
+ chunk_xfer->tx_buf = chunk.buf;
+ chunk_xfer->len = chunk.len;
+
+ /* Calculate next chunk */
+ chunk.buf += chunk.len;
+ chunk.reg_addr += chunk.len / 4;
+ chunk.len = min_t(size_t, (ptrdiff_t)(buf + len - chunk.buf),
+ SJA1105_SIZE_SPI_MSG_MAXLEN);
+
+ /* De-assert the chip select after each chunk. */
+ if (chunk.len)
+ chunk_xfer->cs_change = 1;
+ }
- rc = spi_sync(spi, &m);
- if (rc < 0) {
+ rc = spi_sync_transfer(spi, xfers, 2 * num_chunks);
+ if (rc < 0)
dev_err(&spi->dev, "SPI transfer failed: %d\n", rc);
- return rc;
- }
- if (rw == SPI_READ)
- memcpy(packed_buf, rx_buf + SJA1105_SIZE_SPI_MSG_HEADER,
- size_bytes);
+ kfree(hdr_bufs);
+ kfree(xfers);
- return 0;
+ return rc;
}
/* If @rw is:
@@ -134,43 +175,6 @@ int sja1105_xfer_u32(const struct sja1105_private *priv,
return rc;
}
-/* Should be used if a @packed_buf larger than SJA1105_SIZE_SPI_MSG_MAXLEN
- * must be sent/received. Splitting the buffer into chunks and assembling
- * those into SPI messages is done automatically by this function.
- */
-static int sja1105_xfer_long_buf(const struct sja1105_private *priv,
- sja1105_spi_rw_mode_t rw, u64 base_addr,
- void *packed_buf, u64 buf_len)
-{
- struct chunk {
- void *buf_ptr;
- int len;
- u64 spi_address;
- } chunk;
- int distance_to_end;
- int rc;
-
- /* Initialize chunk */
- chunk.buf_ptr = packed_buf;
- chunk.spi_address = base_addr;
- chunk.len = min_t(int, buf_len, SJA1105_SIZE_SPI_MSG_MAXLEN);
-
- while (chunk.len) {
- rc = sja1105_xfer_buf(priv, rw, chunk.spi_address,
- chunk.buf_ptr, chunk.len);
- if (rc < 0)
- return rc;
-
- chunk.buf_ptr += chunk.len;
- chunk.spi_address += chunk.len / 4;
- distance_to_end = (uintptr_t)(packed_buf + buf_len -
- chunk.buf_ptr);
- chunk.len = min(distance_to_end, SJA1105_SIZE_SPI_MSG_MAXLEN);
- }
-
- return 0;
-}
-
/* Back-ported structure from UM11040 Table 112.
* Reset control register (addr. 100440h)
* In the SJA1105 E/T, only warm_rst and cold_rst are
@@ -433,8 +437,8 @@ int sja1105_static_config_upload(struct sja1105_private *priv)
/* Wait for the switch to come out of reset */
usleep_range(1000, 5000);
/* Upload the static config to the device */
- rc = sja1105_xfer_long_buf(priv, SPI_WRITE, regs->config,
- config_buf, buf_len);
+ rc = sja1105_xfer_buf(priv, SPI_WRITE, regs->config,
+ config_buf, buf_len);
if (rc < 0) {
dev_err(dev, "Failed to upload config, retrying...\n");
continue;
This reworks the SPI transfer implementation to make use of more of the SPI core features. The main benefit is to avoid the memcpy in sja1105_xfer_buf(). The memcpy was only needed because the function was transferring a single buffer at a time. So it needed to copy the caller-provided buffer at buf + 4, to store the SPI message header in the "headroom" area. But the SPI core supports scatter-gather messages, comprised of multiple transfers. We can actually use those to break apart every SPI message into 2 transfers: one for the header and one for the actual payload. To keep the behavior the same regarding the chip select signal, it is necessary to tell the SPI core to de-assert the chip select after each chunk. This was not needed before, because each spi_message contained only 1 single transfer. The meaning of the per-transfer cs_change=1 is: - If the transfer is the last one of the message, keep CS asserted - Otherwise, deassert CS We need to deassert CS in the "otherwise" case, which was implicit before. Avoiding the memcpy creates yet another opportunity. The device can't process more than 256 bytes of SPI payload at a time, so the sja1105_xfer_long_buf() function used to exist, to split the larger caller buffer into chunks. But these chunks couldn't be used as scatter/gather buffers for spi_message until now, because of that memcpy (we would have needed more memory for each chunk). So we can now remove the sja1105_xfer_long_buf() function and have a single implementation for long and short buffers. Another benefit is lower usage of stack memory. Previously we had to store 2 SPI buffers for each chunk. Due to the elimination of the memcpy, we can now send pointers to the actual chunks from the caller-supplied buffer to the SPI core. Since the patch merges two functions into a rewritten implementation, the function prototype was also changed, mainly for cosmetic consistency with the structures used within it. Signed-off-by: Vladimir Oltean <olteanv@gmail.com> --- drivers/net/dsa/sja1105/sja1105.h | 2 +- drivers/net/dsa/sja1105/sja1105_spi.c | 164 +++++++++++++------------- 2 files changed, 85 insertions(+), 81 deletions(-)