Message ID | 4E806377.70701@denx.de |
---|---|
State | Accepted |
Delegated to: | Albert ARIBAUD |
Headers | show |
Hi Stefano, On 26/09/2011 13:35, Stefano Babic wrote: > Hi Albert, > > please pull u-boot-imx/next (already rebased on u-boot-arm/next after > you merged u-boot-ti) into your u-boot-arm/next. > > Best regards, > Stefano > > The following changes since commit f3340eeaf574b3297e801a563089c90d23e84f8d: > > arm, davinci, da8xx: add cpuinfo (2011-09-23 15:50:39 -0400) > > are available in the git repository at: > git://www.denx.de/git/u-boot-imx.git next > > Fabio Estevam (25): > ARM: mx25: Print the silicon revison > ARM: mx25: Print the source of reset > MX31: mx31pdk: Remove nand_spl config.mk file > MX31: Improve readability for reset cause > mx31pdk: Change the prompt as per other i.MX boards > MX25: tx25: Avoid the usage of extern in C file > MX25: Add initial support for MX25PDK > MX31: Disable watchdog during low-power modes > mx31pdk: Remove dram_init_banksize() > mx25pdk: Remove dram_init_banksize() > mx31ads: Remove dram_init_banksize() > imx31_litekit: Remove dram_init_banksize() > mx31pdk: Place machine ID into board config > mx25pdk: Place machine ID into board config > mx31ads: Place machine ID into board config > imx31_litekit: Place machine ID into board config > mx51evk: Place machine ID into board config > mx53loco: Place machine ID into board config > mx53smd: Place machine ID into board config > mx53ard: Place machine ID into board config > mx53evk: Place machine ID into board config > zmx25: Remove dram_init_banksize() > zmx25: Place machine ID into board config > zmx25: Fix build warning due to 'get_reset_cause' defined but not used > vision2: Place machine ID into board config > > Jason Liu (1): > cosmetic: fsl_pmic: cosmetic for the help message > > Marek Vasut (19): > EfikaMX: Adjust undocumented magic constant in config file > FEC: Use proper accessor to read register in debug call > FEC: Use defined constant instead of magic number > FEC: Kill mode select FIXME's > FEC: Add RMII mode support > FEC: Allow selection of MII mode via CONFIG_FEC_XCV_TYPE > FEC: Abstract access to fec->eth in MII operations > FEC: Allow multiple FECes > FEC: Allow registering MII postconfiguration callback > FEC: Add timeout for chip reset > FEC: Squish "got MAC from fuse" message, make it debug() > FEC: Move imx_get_mac_from_fuse() definition to fec_mxc.h > MX5: Modify the PLL decoding algorithm > MX5: Add AHB clock reporting and fix IPG clock reporting > MX5: Clean up the output of "clocks" command > I2C: mxc_i2c rework > ATA: Squash warnings in mxc_ata. > EfikaMX: Add imximage config for Efika SB > EfikaSB: Add preliminary EfikaSB support Applied to u-boot-arm/next, thanks! Amicalement,