@@ -8,8 +8,8 @@
#include <asm/mach-imx/regs-lcdif.h>
-#define ROM_VERSION_A0 0x800
-#define ROM_VERSION_B0 0x83C
+#define ROM_VERSION_A0 IS_ENABLED(CONFIG_IMX8MQ) ? 0x800 : 0x800
+#define ROM_VERSION_B0 IS_ENABLED(CONFIG_IMX8MQ) ? 0x83C : 0x800
#define M4_BOOTROM_BASE_ADDR 0x007E0000
@@ -91,7 +91,11 @@
#define SEMAPHOR_HS_BASE_ADDR 0x30AC0000
#define USDHC1_BASE_ADDR 0x30B40000
#define USDHC2_BASE_ADDR 0x30B50000
+#ifdef CONFIG_IMX8MM
+#define USDHC3_BASE_ADDR 0x30B60000
+#else
#define MIPI_CS2_BASE_ADDR 0x30B60000
+#endif
#define MIPI_CSI_PHY2_BASE_ADDR 0x30B70000
#define CSI2_BASE_ADDR 0x30B80000
#define QSPI0_BASE_ADDR 0x30BB0000
@@ -118,7 +122,8 @@
#define USB1_PHY_BASE_ADDR 0x381F0000
#define USB2_PHY_BASE_ADDR 0x382F0000
-#define MXS_LCDIF_BASE LCDIF_BASE_ADDR
+#define MXS_LCDIF_BASE is_enable(CONFIG_IMX8MQ) ? \
+ 0x30320000 : 0x32e00000
#define SRC_IPS_BASE_ADDR 0x30390000
#define SRC_DDRC_RCR_ADDR 0x30391000
@@ -147,6 +152,9 @@
#define SRC_DDR1_RCR_CORE_RESET_N_MASK BIT(1)
#define SRC_DDR1_RCR_PRESET_N_MASK BIT(0)
+#define IOMUXC_GPR_GPR1_GPR_ENET1_TX_CLK_SEL_MASK 0x2000u
+#define IOMUXC_GPR_GPR1_GPR_ENET1_TX_CLK_SEL_SHIFT 13
+
struct iomuxc_gpr_base_regs {
u32 gpr[47];
};
@@ -203,6 +211,7 @@ struct fuse_bank1_regs {
u32 rsvd3[3];
};
+#ifdef CONFIG_IMX8MQ
struct anamix_pll {
u32 audio_pll1_cfg0;
u32 audio_pll1_cfg1;
@@ -237,6 +246,60 @@ struct anamix_pll {
u32 frac_pllout_div_cfg;
u32 sscg_pllout_div_cfg;
};
+#else
+struct anamix_pll {
+ u32 audio_pll1_gnrl_ctl;
+ u32 audio_pll1_fdiv_ctl0;
+ u32 audio_pll1_fdiv_ctl1;
+ u32 audio_pll1_sscg_ctl;
+ u32 audio_pll1_mnit_ctl;
+ u32 audio_pll2_gnrl_ctl;
+ u32 audio_pll2_fdiv_ctl0;
+ u32 audio_pll2_fdiv_ctl1;
+ u32 audio_pll2_sscg_ctl;
+ u32 audio_pll2_mnit_ctl;
+ u32 video_pll1_gnrl_ctl;
+ u32 video_pll1_fdiv_ctl0;
+ u32 video_pll1_fdiv_ctl1;
+ u32 video_pll1_sscg_ctl;
+ u32 video_pll1_mnit_ctl;
+ u32 reserved[5];
+ u32 dram_pll_gnrl_ctl;
+ u32 dram_pll_fdiv_ctl0;
+ u32 dram_pll_fdiv_ctl1;
+ u32 dram_pll_sscg_ctl;
+ u32 dram_pll_mnit_ctl;
+ u32 gpu_pll_gnrl_ctl;
+ u32 gpu_pll_div_ctl;
+ u32 gpu_pll_locked_ctl1;
+ u32 gpu_pll_mnit_ctl;
+ u32 vpu_pll_gnrl_ctl;
+ u32 vpu_pll_div_ctl;
+ u32 vpu_pll_locked_ctl1;
+ u32 vpu_pll_mnit_ctl;
+ u32 arm_pll_gnrl_ctl;
+ u32 arm_pll_div_ctl;
+ u32 arm_pll_locked_ctl1;
+ u32 arm_pll_mnit_ctl;
+ u32 sys_pll1_gnrl_ctl;
+ u32 sys_pll1_div_ctl;
+ u32 sys_pll1_locked_ctl1;
+ u32 reserved2[24];
+ u32 sys_pll1_mnit_ctl;
+ u32 sys_pll2_gnrl_ctl;
+ u32 sys_pll2_div_ctl;
+ u32 sys_pll2_locked_ctl1;
+ u32 sys_pll2_mnit_ctl;
+ u32 sys_pll3_gnrl_ctl;
+ u32 sys_pll3_div_ctl;
+ u32 sys_pll3_locked_ctl1;
+ u32 sys_pll3_mnit_ctl;
+ u32 anamix_misc_ctl;
+ u32 anamix_clk_mnit_ctl;
+ u32 reserved3[437];
+ u32 digprog;
+};
+#endif
struct fuse_bank9_regs {
u32 mac_addr0;
@@ -256,11 +319,13 @@ struct src {
u32 usbophy2_rcr;
u32 mipiphy_rcr;
u32 pciephy_rcr;
+ /* Exits on i.MX8MQ */
u32 hdmi_rcr;
u32 disp_rcr;
u32 reserved2[2];
u32 gpu_rcr;
u32 vpu_rcr;
+ /* The following four exits on i.MX8MQ */
u32 pcie2_rcr;
u32 mipiphy1_rcr;
u32 mipiphy2_rcr;
@@ -283,6 +348,7 @@ struct src {
u32 gpr10;
u32 reserved5[985];
u32 ddr1_rcr;
+ /* Exist on i.MX8MQ */
u32 ddr2_rcr;
};
@@ -457,7 +523,8 @@ struct bootrom_sw_info {
u32 reserved_3[3];
};
-#define ROM_SW_INFO_ADDR_B0 0x00000968
+#define ROM_SW_INFO_ADDR_B0 (IS_ENABLED(CONFIG_IMX8MQ) ? 0x00000968 :\
+ 0x000009e8)
#define ROM_SW_INFO_ADDR_A0 0x000009e8
#define ROM_SW_INFO_ADDR is_soc_rev(CHIP_REV_1_0) ? \
i.MX8MM has similar architecture with i.MX8MQ, but it has totally different PLL design and some register layout change. Note: Some registers in this file are not updated because not used now. Signed-off-by: Peng Fan <peng.fan@nxp.com> --- arch/arm/include/asm/arch-imx8m/imx-regs.h | 75 ++++++++++++++++++++++++++++-- 1 file changed, 71 insertions(+), 4 deletions(-)