[v3,2/6] dt-bindings: usb: add binding for Type-B GPIO connector driver
diff mbox series

Message ID 1554257354-7440-3-git-send-email-chunfeng.yun@mediatek.com
State Superseded
Headers show
Series
  • add USB Type-B GPIO connector driver
Related show

Checks

Context Check Description
robh/checkpatch success

Commit Message

Chunfeng Yun April 3, 2019, 2:09 a.m. UTC
It's used to support dual role switch via GPIO when use Type-B
receptacle, typically the USB ID pin is connected to an input
GPIO pin

Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
---
v3 changes:
 1. treat type-B connector as a virtual device, but not child device of
    USB controller's

v2 changes:
  1. new patch to make binding clear suggested by Hans
---
 .../bindings/usb/typeb-conn-gpio.txt          | 49 +++++++++++++++++++
 1 file changed, 49 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt

Patch
diff mbox series

diff --git a/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
new file mode 100644
index 000000000000..d2e1c4e01b6d
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
@@ -0,0 +1,49 @@ 
+USB Type-B GPIO Connector
+
+This is a virtual device used to switch dual role mode from the USB ID pin
+connected to an input GPIO pin.
+
+Required properties:
+- compatible : Should be "linux,typeb-conn-gpio"
+
+Sub-nodes:
+- connector : should be present.
+	- compatible : should be "usb-b-connector".
+	- id-gpios, vbus-gpios : either one of them must be present,
+		and both can be present as well.
+	- vbus-supply : can be present if needed when supports dual role mode.
+	see connector/usb-connector.txt
+
+- port : should be present.
+	see graph.txt
+
+Example:
+
+rsw_iddig: role_sw_iddig {
+	compatible = "linux,typeb-conn-gpio";
+	status = "okay";
+
+	connector {
+		compatible = "usb-b-connector";
+		label = "micro-USB";
+		type = "micro";
+		id-gpios = <&pio 12 GPIO_ACTIVE_HIGH>;
+		vbus-supply = <&usb_p0_vbus>;
+	};
+
+	port {
+		bconn_ep: endpoint@0 {
+			remote-endpoint = <&usb_role_sw>;
+		};
+	};
+};
+
+&mtu3 {
+	status = "okay";
+
+	port {
+		usb_role_sw: endpoint@0 {
+			remote-endpoint = <&bconn_ep>;
+		};
+	};
+};