[net-next,v2] net: dsa: qca8k: Enable delay for RGMII_ID mode
diff mbox series

Message ID 20190219065943.22765-1-vkoul@kernel.org
State Accepted
Delegated to: David Miller
Headers show
Series
  • [net-next,v2] net: dsa: qca8k: Enable delay for RGMII_ID mode
Related show

Commit Message

Vinod Koul Feb. 19, 2019, 6:59 a.m. UTC
RGMII_ID specifies that we should have internal delay, so resurrect the
delay addition routine but under the RGMII_ID mode.

Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode")
Tested-by: Michal Vokáč <michal.vokac@ysoft.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
---
 drivers/net/dsa/qca8k.c | 12 ++++++++++++
 drivers/net/dsa/qca8k.h |  1 +
 2 files changed, 13 insertions(+)

Comments

Andrew Lunn Feb. 19, 2019, 12:58 p.m. UTC | #1
On Tue, Feb 19, 2019 at 12:29:43PM +0530, Vinod Koul wrote:
> RGMII_ID specifies that we should have internal delay, so resurrect the
> delay addition routine but under the RGMII_ID mode.
> 
> Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode")
> Tested-by: Michal Vokáč <michal.vokac@ysoft.com>
> Signed-off-by: Vinod Koul <vkoul@kernel.org>

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew
David Miller Feb. 19, 2019, 9:19 p.m. UTC | #2
From: Vinod Koul <vkoul@kernel.org>
Date: Tue, 19 Feb 2019 12:29:43 +0530

> RGMII_ID specifies that we should have internal delay, so resurrect the
> delay addition routine but under the RGMII_ID mode.
> 
> Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode")
> Tested-by: Michal Vokáč <michal.vokac@ysoft.com>
> Signed-off-by: Vinod Koul <vkoul@kernel.org>

Applied, thanks.

Patch
diff mbox series

diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index a4b6cda38016..195a8a87b984 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c
@@ -443,6 +443,18 @@  qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode)
 		val = QCA8K_PORT_PAD_RGMII_EN;
 		qca8k_write(priv, reg, val);
 		break;
+	case PHY_INTERFACE_MODE_RGMII_ID:
+		/* RGMII_ID needs internal delay. This is enabled through
+		 * PORT5_PAD_CTRL for all ports, rather than individual port
+		 * registers
+		 */
+		qca8k_write(priv, reg,
+			    QCA8K_PORT_PAD_RGMII_EN |
+			    QCA8K_PORT_PAD_RGMII_TX_DELAY(QCA8K_MAX_DELAY) |
+			    QCA8K_PORT_PAD_RGMII_RX_DELAY(QCA8K_MAX_DELAY));
+		qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL,
+			    QCA8K_PORT_PAD_RGMII_RX_DELAY_EN);
+		break;
 	case PHY_INTERFACE_MODE_SGMII:
 		qca8k_write(priv, reg, QCA8K_PORT_PAD_SGMII_EN);
 		break;
diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h
index 613fe5c50236..d146e54c8a6c 100644
--- a/drivers/net/dsa/qca8k.h
+++ b/drivers/net/dsa/qca8k.h
@@ -40,6 +40,7 @@ 
 						((0x8 + (x & 0x3)) << 22)
 #define   QCA8K_PORT_PAD_RGMII_RX_DELAY(x)		\
 						((0x10 + (x & 0x3)) << 20)
+#define   QCA8K_MAX_DELAY				3
 #define   QCA8K_PORT_PAD_RGMII_RX_DELAY_EN		BIT(24)
 #define   QCA8K_PORT_PAD_SGMII_EN			BIT(7)
 #define QCA8K_REG_MODULE_EN				0x030