@@ -43,7 +43,7 @@ set_state() {
status_led="spw303v:green:power+adsl"
;;
vh4032n)
- status_led="VH4032N:red:power"
+ status_led="VH4032N:blue:power"
;;
vr-3025un)
status_led="VR-3025un:green:power"
@@ -26,10 +26,10 @@
debounce-interval = <60>;
};
- wps {
- label = "wps";
+ wlan {
+ label = "wlan";
gpios = <&pinctrl 35 1>;
- linux,code = <KEY_WPS_BUTTON>;
+ linux,code = <KEY_WLAN>;
debounce-interval = <60>;
};
};
@@ -56,11 +56,11 @@
power_blue {
label = "VH4032N:blue:power";
gpios = <&pinctrl 22 0>;
+ default-state = "on";
};
power_red {
label = "VH4032N:red:power";
gpios = <&pinctrl 24 0>;
- default-state = "on";
};
voice_blue {
label = "VH4032N:blue:voice";
- use the blue LED for power, since the red LED is already used by CFE in emergency mode. - use the correct code for the wlan button Signed-off-by: Daniel Gonzalez Cabanelas <dgcbueu@gmail.com> --- Changes in v2: - the v1 patch was truncated, fixed target/linux/brcm63xx/base-files/etc/diag.sh | 2 +- target/linux/brcm63xx/dts/vh4032n.dts | 8 ++++---- 2 files changed, 5 insertions(+), 5 deletions(-)