bisected regression, v3.5 -> next-20120724: PCI PM causes USB hotplug failure

On Fri, 2012-07-27 at 11:11 +0200, Bjørn Mork wrote:
> Huang Ying <ying.huang@intel.com> writes:
> 
> > Do you have time to try the following patch?
> >
> > Best Regards,
> > Huang Ying
> >
> > ---
> >  drivers/pci/pci-driver.c |    6 ++++++
> >  1 file changed, 6 insertions(+)
> >
> > --- a/drivers/pci/pci-driver.c
> > +++ b/drivers/pci/pci-driver.c
> > @@ -280,8 +280,12 @@ static long local_pci_probe(void *_ddi)
> >  {
> >  	struct drv_dev_and_id *ddi = _ddi;
> >  	struct device *dev = &ddi->dev->dev;
> > +	struct device *parent = dev->parent;
> >  	int rc;
> >  
> > +	/* The parent bridge must be in active state when probing */
> > +	if (parent)
> > +		pm_runtime_get_sync(parent);
> >  	/* Unbound PCI devices are always set to disabled and suspended.
> >  	 * During probe, the device is set to enabled and active and the
> >  	 * usage count is incremented.  If the driver supports runtime PM,
> > @@ -298,6 +302,8 @@ static long local_pci_probe(void *_ddi)
> >  		pm_runtime_set_suspended(dev);
> >  		pm_runtime_put_noidle(dev);
> >  	}
> > +	if (parent)
> > +		pm_runtime_put(parent);
> >  	return rc;
> >  }
> >  
> 
> 
> Yup, that worked in the quick test I just did.
> 
>  lspci reading the device config will still not wake the bridge, but I
> assume that is intentional?  But loading the device driver now wakes
> both the bridge and the device, so that works.

Do you have time to test the following patch to fix the lspci issue?

Subject: [BUGFIX] PCI/PM: Keep parent bridge active when read/write config reg

This patch fixes the following bug:

http://marc.info/?l=linux-pci&m=134338059022620&w=2

Where lspci does not work properly if a device and the corresponding
parent bridge (such as PCIe port) is suspended.  This is because the
device configuration space registers will be not accessible if the
corresponding parent bridge is suspended.

To solve the issue, the bridge/PCIe port connected to the device is
put into active state before read/write configuration space registers.

To avoid resume/suspend PCIe port for each configuration register
read/write, a small delay is added before the PCIe port to go
suspended.

Reported-by: Bjorn Mork <bjorn@mork.no>
Signed-off-by: Huang Ying <ying.huang@intel.com>
---
 drivers/pci/pci-sysfs.c        |   14 ++++++++++++++
 drivers/pci/pcie/portdrv_pci.c |    9 +++++++++
 2 files changed, 23 insertions(+)

--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

bisected regression, v3.5 -> next-20120724: PCI PM causes USB hotplug failure

Commit Message

Comments

Patch