@@ -197,10 +197,16 @@ static int amd_gpio_set_config(struct gpio_chip *gc, unsigned offset,
static void amd_gpio_dbg_show(struct seq_file *s, struct gpio_chip *gc)
{
u32 pin_reg;
+ u32 db_cntrl;
unsigned long flags;
unsigned int bank, i, pin_num;
struct amd_gpio *gpio_dev = gpiochip_get_data(gc);
+ bool tmr_out_unit;
+ unsigned int time;
+ unsigned int unit;
+ bool tmr_large;
+
char *level_trig;
char *active_level;
char *interrupt_enable;
@@ -214,6 +220,8 @@ static void amd_gpio_dbg_show(struct seq_file *s, struct gpio_chip *gc)
char *pull_down_enable;
char *output_value;
char *output_enable;
+ char debounce_value[40];
+ char *debounce_enable;
for (bank = 0; bank < gpio_dev->hwbank_num; bank++) {
seq_printf(s, "GPIO bank%d\t", bank);
@@ -327,13 +335,44 @@ static void amd_gpio_dbg_show(struct seq_file *s, struct gpio_chip *gc)
pin_sts = "input is low|";
}
+ db_cntrl = (DB_CNTRl_MASK << DB_CNTRL_OFF) & pin_reg;
+ if (db_cntrl) {
+ tmr_out_unit = pin_reg & BIT(DB_TMR_OUT_UNIT_OFF);
+ tmr_large = pin_reg & BIT(DB_TMR_LARGE_OFF);
+ time = pin_reg & DB_TMR_OUT_MASK;
+ if (tmr_large) {
+ if (tmr_out_unit)
+ unit = 62500;
+ else
+ unit = 15625;
+ } else {
+ if (tmr_out_unit)
+ unit = 244;
+ else
+ unit = 61;
+ }
+ if ((DB_TYPE_REMOVE_GLITCH << DB_CNTRL_OFF) == db_cntrl)
+ debounce_enable = "debouncing filter (high and low) enabled|";
+ else if ((DB_TYPE_PRESERVE_LOW_GLITCH << DB_CNTRL_OFF) == db_cntrl)
+ debounce_enable = "debouncing filter (low) enabled|";
+ else
+ debounce_enable = "debouncing filter (high) enabled|";
+
+ snprintf(debounce_value, sizeof(debounce_value),
+ "debouncing timeout is %u (us)|", time * unit);
+ } else {
+ debounce_enable = "debouncing filter disabled|";
+ snprintf(debounce_value, sizeof(debounce_value), " ");
+ }
+
seq_printf(s, "%s %s %s %s %s %s\n"
- " %s %s %s %s %s %s %s 0x%x\n",
+ " %s %s %s %s %s %s %s %s %s 0x%x\n",
level_trig, active_level, interrupt_enable,
interrupt_mask, wake_cntrl0, wake_cntrl1,
wake_cntrl2, pin_sts, pull_up_sel,
pull_up_enable, pull_down_enable,
- output_value, output_enable, pin_reg);
+ output_value, output_enable,
+ debounce_enable, debounce_value, pin_reg);
}
}
}
Print the status of debounce filter as follows, $ cat /sys/kernel/debug/gpio pin129 interrupt is disabled| interrupt is masked| disable wakeup in S0i3 state| disable wakeup in S3 state| disable wakeup in S4/S5 state| input is high| pull-up is disabled| Pull-down is disabled| output is disabled| debouncing filter disabled| 0x50000 ^^^^^^^^^^^^^^^^^^^^^^^^^^ pin130 interrupt is disabled| interrupt is masked| disable wakeup in S0i3 state| disable wakeup in S3 state| disable wakeup in S4/S5 state| input is high| pull-up is disabled| Pull-down is disabled| output is disabled| debouncing filter (high) enabled| debouncing timeout is 124800 (us)| 0x503c8 ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Signed-off-by: Coiby Xu <coiby.xu@gmail.com> --- drivers/pinctrl/pinctrl-amd.c | 43 +++++++++++++++++++++++++++++++++-- 1 file changed, 41 insertions(+), 2 deletions(-)